Advertisement
Quick Links
Advertisement
Summary of Contents for PNH FY 400 G
- Page 1 INSTRUCTION MANUAL Gas Grilling Plates FY 400 G FY 600 G FY 800 G FYG3/2...
- Page 2 Symbols used in this manual Read the instructions before using the appliance Important instructions for safety. Danger of imminent accident if they are not observed Practical note for the user. Instructions only for qualified personnel. Introduction: Congratulations excellent choice have just made...
- Page 3 5. Feet with height adjustment. 6. Frontal fats collector along its whole length. 2. Characteristics: 1. Work plan with anti-stick coating in flat / wavy / mixed, 6mm / 10mm / 14mm steel (depending on the model purchased). 2. front panel in stainless steel or coloured: black / copper / gold / chocolate / rainbow / anthracite (depending on the model purchased).
- Page 4 3. General characteristics table: Nominal Consumption Dim. Dim. Weight Weight Propan Natural Placa Dim. Produt Power Butane Model Embalagem Líquido Bruto (área útil) LxPxA (mm) (Kw) 30mbar LxPxA (mm) (Kg) (Kg) 37mbar 20mbar LxP (mm) (g/h) (g/h) (l/h) FY 400G FLAT PLATE 390x400 285.5...
- Page 5 4. Types of gas, injectors and categories: Type of Gas Pressure (mbar) Injector (mm) Category G-20 (Natural Gas) 1.15 2H/2E+ G-30 (L.P.G.) 0.93 G-31 (L.P.G.) 0.85 5. Installation: Authorized technicians only Carefully unpack the equipment, check if it is in perfect condition. Remove all plastic packaging materials, adhesives, ...
- Page 6 6. Use: After removing all plastic, clean the plate with an appropriate detergent and then grease the plate. To start the plate press the knob and turn it counter- clockwise to the maximum position (large flame print ), then press the lighter one or more times, observe if the flame lit, if so keep the knob pressed for 10 to 15 seconds more.
- Page 7 8. Adapting to a different type of gas : Authorized technicians only To change the type of gas for which the unit is ready, proceed as follows: 1. Close the gas shut-off valve of the equipment. 2. Turn the fry top with the plate down. 3.
- Page 8 7. Remove the knobs of the valves with the burners at minimum position, use a screwdriver to adjust the flame to a minimum so that it has enough size to keep the thermocouple hot and the tap does not shut down (wait for a few minutes to make sure that flame is enough).
- Page 9 10. Possible malfunctions/ solutions : Malfunctions Probable causes Burner (s ) Insufficient gas Lighter Lighter Lighter or pressure. (Check connection cable connection cable candle does not light up supply) loose damaged damaged (replace it) (replace it) (turn cable on) Burner (s ) lights Insufficient gas Thermocouple Thermostatic...
- Page 10 11. Replacement Passive Components Authorized repairers only Reference Designation 1MS0067016 piezo electric lighter (FY) 1MS0067014 ignition electrode (cable included) 1MS0067012 thermocouple 8x1 QPLSBF L400 (FY) 1MS0067013 Tap with sec 1 way with joint EC10 front thread (FY) 1MS0067004 Injector butane gas diam.0.93 (FY) 1MS0067005 Injector natural gas diam.
Need help?
Do you have a question about the FY 400 G and is the answer not in the manual?
Questions and answers