Dometic MagicSafe MS 660 Installation And Operating Manual page 50

Using MagicSafe
Number of
Cause of the alarm
flashes
1 Voltage drop sensor
2 Ultrasonic sensors (interior)
3 Door/boot contact switch
4 Bonnet contact switch
5 Ignition
7 Additional alarm input
8 Radio sensor
9 The battery in the hand-held transmitter is too weak
11.8 Using the self-activation function
Self-activation (factory setting: deactivated) refers to the automatic arming of the
alarm system after leaving the vehicle. The ignition must be switched off for this and
the doors must be closed.
To set up self-activation, proceed as follows:
➤ Program software function 7 "Self-activation" to "On".
✓ The alarm system activates itself 10 sec. after the ignition was switched off and a
door was opened and closed again.
I
NOTE
If you have set the system to self-activate, the central locking does not
lock the doors, to prevent you locking yourself out of the car by acci-
dent.
50
MS660
EN