S-IDEE MJX 16207 User Manual page 30

E45A Brushless ESC
Please Do Not forcible/reversely insert all sockets.
!
Indicator
Power switch
VCC/BVD
Heat sink
Yellow wire A
White wire B
Blue wire C
VCC: Powered by battery circuit. Please provide the same voltage as the connected battery. It can be used
as cooling fan power. Please make sure the battery voltage of the ESC is in the range of fan's.
BVD: Receivers with BVD function can be directly connected to this interface through an adapter cable, which
is equivalent to connecting a battery.
T3B Transmitter
①ST.TRIM (Steering servo strimmer)
If the car cannot go straightly during driving, it can
be adjusted through the ST.TRIM.
E45A Indicator
light situation
Flash quickly
Flash slowly
① ST.TRIM
(Steering servo strimmer)
② TH.TRIM (Throttle trimmer)
③ Power switch
(OFF-70%TH-100%TH)
④ Indicator light
⑤ CH1: ST (Steering)
⑥ CH2: TH (Throttle)
⑦ CH3: Fn
②TH.TRIM (Throttle trimmer)
If the car can't be stop when the TH in the
middle place, you can adjust the button to
stop the car.
Forward
-5-
Meanings
Stays on Signaled
a. No signal
b. Pull the trigger
Low voltage
Over heat
Flash twice
protection
Off Stuck protection