Wall hung rsf gas fired condensing boiler (56 pages)
Summary of Contents for Bosch Worcester Greenstar Si Compact ErP
Page 1
User instructions Wall hung RSF gas fired condensing combination boiler Greenstar Si Compact For sealed central heating systems and mains fed domestic hot water These appliances are for use with: Natural Gas or L.P.G. (Cat. II 2H 3P type C13, C33 & C53) Model GC Number Natural Gas 25Si Compact...
Page 2
Group. The company prides itself on manufacturing appliances to the strictest quality control standards throughout every stage of production. Worcester, Bosch group has led the field in innovative appliance design and performance for over 50 years. This heritage means all our products are of exceptional quality and proven reliability.
Key to symbols and safety instructions A step in an action sequence Key to symbols and safety instructions A sequence of defined actions or steps carried out in order to complete a task. Key to symbols ▶ Action ▶ Next action Warnings ▶...
The service record will show a potential purchaser Worcester, Bosch Group accepts no liability arising from any that the heating system has received regular professional such actions. This does not affect your statutory rights.
Controls Controls ▶ To gain access to the boiler controls pull the flap down using the curved flap handle. 12 13 Fig. 1 Basic boiler controls 1 Service menu/back button Scroll down button 2 Service engineer symbol = boiler is set to maximum 10 The blue light is ON when the boiler is in an Boiler or minimum output for service...
Page 7
°C The example shown is H13 Service interval reached, the boiler requires servicing. °F Call your installer or Worcester Bosch Group to H 13 organise a service visit. Table 2 Greenstar Si Compact - 6 720 813 279 (2014/09)
Controls Operating the boiler 3.1.1 Boiler display This is typical of the display when the boiler is not supplying a central heating or hot water demand. The display will not be backlit and the internal temperature of the boiler is displayed. When heat is demanded and the boiler fires up, the flame symbol will be displayed.
Controls 3.1.3 Boiler frost protection If you are leaving your property unoccupied during cold weather, please leave your programmer on constant and your room thermostat set to 15°C. ▶ If the temperature within the boiler falls below 8°C the pump will run to circulate water and prevent the system freezing. –...
Controls 3.1.7 Domestic hot water preheat mode manual activation (Eco mode off) Eco mode is enabled by default and the PreHeat can be can be enabled. 1. Press and hold for at least four seconds to enter the PreHeat mode, when preheat mode is active, “PreHeat” will be displayed.
System Pressure System Pressure Sealed heating system This boiler is fitted to a sealed heating system which is pre-pressurised. Your installer will advise you of the minimum and maximum pressure indicated on the pressure gauge. ▶ Check regularly that the pressure is maintained. ▶...
System Pressure Optional integral keyless filling link Locate filling link and follow instructions for re-pressurising. 1. If the needle on the appliance pressure gauge reads less than 1 bar, re-charge the system. 2. Pull the blue lever down to start the filling process. 3.
System Pressure Optional integral keyed filling link Locate filling key and follow instructions for re-pressurising. 1. Push the filling key firmly into the body of the filling link, ensuring the arrow on the key shaft lines up with the open padlock symbol.
System Pressure External filling loop NOTICE: External filling loops ▶ If the filling loop does not look like the one shown in the figure below or you cannot find your filling loop, contact your installer. ▶ To comply with Water Authority regulations you must disconnect the external filling loop after re- pressurisation.
Service clearances Service clearances Your installer will have provided adequate space around the boiler for safety and servicing access. CAUTION: Restricted space. The boiler may overheat. ▶ Do not restrict this space with the addition of cupboards, shelves etc. next to the boiler. NOTICE: Combustible and corrosive materials: Chemically aggressive substances can corrode the appliance and invalidate any guarantee.
If your Greenstar gas-fired appliance should fail to operate correctly or requires servicing, please contact the Worcester, Bosch Group Appointments Team (see rear cover for details).
In the event that the appliance stops functioning or does not perform as expected, please see table below These problems are some of the most common causes. Should the problem persist or if other fault codes are displayed, then it will be necessary to contact Worcester, Bosch Group. This table gives information on basic operating system problems.
Worcester, Bosch Group for further assistance. When calling Worcester, Bosch Group about a fault, it will be useful to quote the alert code and three digit number under the alert code, e.g. EA and 227. If there is a fault that cannot be reset by you, the user, then a service engineer visit will be necessary.
Hot water, but not boiling, can also be poured onto the pipe from a watering can or similar container. Care must be taken at pedestrian areas where this water may freeze and create a slip hazard. ▶ Worcester, Bosch Group have available on our website helpful videos in the Customer service section to aid in thawing a frozen pipe.
In the case of a suspected fault, refer to the fault finding section of this guide. In the event of a boiler fault or breakdown please contact Worcester, Bosch Group appointments team on 0330 123 9339. Your advisor will arrange for an engineer to call with the minimum of delay; under normal circumstances this will be from 1 - 3 working days (excluding weekends and bank holidays) for priority breakdown situations (no hot water and/or heating).
Tips on energy saving Tips on energy saving Heating economically The appliance provides a high level of comfort whilst keeping gas consumption low and so minimising the environmental impact. The gas supply to the appliance‘s burner is regulated according to the demand for heat. The appliance operates with a low flame if the demand for heat reduces.
The householder may be asked to prove the date of installation, that the boiler was correctly commissioned and, where appropriate, the first year's service has been carried out to the satisfaction of Bosch Thermotechnology Ltd., when requested. These should be documented as a part of the Benchmark Checklist.
Glossary Glossary Central heating systems All radiators must be heated at an even rate. If the top of a radiator is at a lower temperature than the bottom then it should be bled by releasing air through the bleed screw at the top of the radiator. Ask your installer to show you how this is done.
Page 24
0330 123 9119 TRAINING: 0330 123 0166 SALES: 0330 123 9669 Worcester, Bosch Group Cotswold Way, Warndon, Worcester WR4 9SW. Tel. 0330 123 9559 Worcester, Bosch Group is a brand name of Bosch Thermotechnology Ltd. worcester-bosch.co.uk 6 720 813 279 (2014/09)
Need help?
Do you have a question about the Worcester Greenstar Si Compact ErP and is the answer not in the manual?
Questions and answers