Adjust Program; Settings; Loading The Laundry; Filling In Detergent And Care - Bosch WGG244A20 Instructions For Use And Assembly

enservice
Turn the program selector and set it
1.
to the required programme.
→ "programs", page 26
If necessary, adjust program
2.
settings → page 32 .
13.3 Customize program

settings

Precondition:A program is set.
→ "Set program", page 31
Adjust the program settings.
▶
→
"Buttons", page 24
Hints
¡The program settings are
not saved permanently for the
program.
¡If you use the intelligent dosing
activate or deactivate the system,
the setting is saved.
13.4 Load laundry
A notice:To avoid creasing, observe
the maximum load of the
→ "programs", page 26 .
Precondition:The laundry is prepared.
→ "Laundry", page 30
Open the door.
1.
Make sure the drum is empty.
Put the laundry in the drum.
2.
Close the door.
3.
Make sure no laundry is caught in
the door.
32
13.5 Fill in detergent and care

products

For programs in which intelligent
dosing is not possible or desired, you
can add detergent manually.
Tip:In addition to the intelligent
dosing, you can also add other care
products for laundry such as e.g. B.
Add stain remover, starch or bleach.
Do not add additional detergent to the
manual dosing compartment to
prevent over dosing or foaming.
A notice:Observe the information on
detergents and care products
→ page 31 .
Pull out the detergent drawer.
1.
Fill in the detergent.
2.
→ "Detergent drawer", page
19
If necessary, fill in the care product.
3.
Push in the detergent drawer.
4.
13.6 Start program
A notice:If you want to change the time
until the end of the programme, set
the Ready in time first.
onStart/Reloadto press.
▶
aThe drum rotates and it
A load detection follows, which can
last up to 2 minutes and then the
water runs in. aThe display shows
either pro-
gram duration or the Ready in time is
displayed.
aThe display shows after program
mende: "End".