Pool Maintenance & Chemicals; Troubleshooting - Intex PRISM FRAME 126712GN Manual

(315IO) Prism Frame™ Premium Pool / Greywood Prism Frame™ Premium Pool ENGLISH 7.5" X 10.3" PANTONE 295U 05/19/2022
POOL MAINTENANCE & CHEMICALS
REMEMBER TO
• Protect all pool occupants from possible water-related illnesses by keeping the pool water
clean and sanitized. Do not swallow the pool water. Always practice good hygiene.
• Keep your pool clean and clear. The pool floor must be visible at all times from the outside
barrier of the pool.
• Keep children away from pool covers to avoid entanglement, drowning, or other serious
injury.
Water maintenance
The maintenance of a proper water balance through appropriate use of sanitizers is the single most
important factor in maximizing the life and appearance of the liner as well as ensuring clean, healthy
and safe water. Proper technique is important for water testing and treating the pool water. See your
pool professional for chemical, test kits and testing procedures. Be sure to read and follow the
written instructions from the chemical manufacturer.
1. Never let chlorine come in contact with the liner if it is not completely dissolved. Dissolve granular or
tablet chlorine first in a bucket of water, then add it to the pool water. Likewise with liquid chlorine; mix it
immediately and thoroughly with the pool water.
2. Never mix chemicals together. Add the chemicals to the pool water separately. Thoroughly dissolve each
chemical before adding another one to the water.
3. An Intex pool skimmer and an Intex pool vacuum are available to assist in maintaining clean pool water.
See your pool dealer for these pool accessories.
4. Do not use a pressure washer to clean the pool.
PROBLEM
ALGAE • Greenish water.
• Green or black spots
on pool liner.
• Pool liner is slippery
and/or has a bad odor.
COLORED • Water turns blue,
WATER brown, or black when
first treated with
chlorine.
FLOATING • Water is cloudy or
MATTER IN milky.
WATER
CHRONIC LOW • Level is lower than
WATER LEVEL on previous day.
SEDIMENT ON • Dirt or sand on pool
POOL BOTTOM floor.
SURFACE DEBRIS • Leaves, insects etc.
SAVE THESE INSTRUCTIONS
WARNING

TROUBLESHOOTING

DESCRIPTION CAUSE
• Chlorine and pH level
need adjustment.
• Copper, iron or
manganese in water
being oxidized by the
added chlorine.
• "Hard water" caused by a
too high pH level.
• Chlorine content is low.
• Foreign matter in water.
• Rip or hole in pool liner
or hoses.
• Heavy use, getting in
and out of pool.
• Pool too close to trees.
English
SOLUTION
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH to recommended
level.
• Run filter until water is clear.
• Replace cartridge frequently.
• Correct the pH level. Check with
your pool dealer for advice.
• Check for proper chlorine level.
• Clean or replace your filter cartridge.
• Repair with patch kit.
• Finger tighten all caps.
• Replace the hoses.
• Use Intex pool vacuum to
clean bottom of pool.
• Use Intex pool skimmer.
Page 11
315
A