Next, set the water control to 'OFF' if the fan only
is required or progressively anti-clockwise towards
'ON' to increase the cooling effect.
There is an airflow direction control on the front grill,
to aim the flow in the required direction.
Turn the ON/OFF/Fan speed control to give the
desired airflow. This dial also switches the unit OFF
when set to 'OFF'.
Next, raise the water flow lever to stop any water
flow if the fan only is required or lower the lever
for a cooling effect.
There are two airflow direction controls. The airflow
up/down control lever manually sets the vertical
airflow.
The vertical swing controls is a powered system
which moves the deflectors from left to right
continuously when set to ON.
If you need the air to be sent in one direction, set the
louver ON then OFF once in the required position.
Turn the 3-speed fan control to give the desired
airflow.
Next, set the water control anti-clockwise if the fan
only is required or progressively clockwise to
increase the cooling effect.
Turn the fan control anti-clockwise for fan only (3
speed settings), and clockwise for fan with cooling
(3 settings).
All Models...
NOTE: Full fan and full water flow will act as a
humidifier, placing moisture back into the air.
EQUIPMENT CARE
Never use a cooler except for its intended purpose.
If it will not do what you want with reasonable ease and
speed, assume you have the wrong type of cooler for the
job. Contact your local HSS Hire Shop for advice.
Keep the equipment clean - you will find this less of a
chore if you clean it regularly, rather than wait until the
end of the hire period.
Water Resevoir
Because the HSS Evaporative Coolers have a
reservoir of water, which cannot be emptied
safely by the user, it is important that the unit
is not stored for more than 2 days without
being used.
If the unit is required but not used for 2 days,
either run the unit for 1 hour in every 24 or
request a replacement from your local HSS
Hire Shop.
When not in use, store the equipment somewhere
clean, dry and safe from thieves. Protect this
equipment from frost and freezing conditions.
All manuals and user guides at all-guides.com
FINISHING OFF
Set the controls to fan only and let the unit run for
10 minutes to dry the water pads.
Switch the unit OFF and give it a final clean up
ready for return, to your local HSS Hire Shop.
...any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 020 8687 5001
©HSS Hire Service Group Plc 2003 No. 612/02
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
Operating & Safety Guide 612
Evaporative
Coolers
Fan assisted cooler/humidifier, using the
cooling effect of water evaporation.
Code 56772/56781/56782
Need help?
Do you have a question about the 56781 and is the answer not in the manual?
Questions and answers