Summary of Contents for Gaggenau WD200140
- Page 1 Gaggenau Instruction Manual and Installation Instructions WD200140 Washer dryer...
-
Page 2: Table Of Contents
Contents General safety information ............3 Operation instructions Environmental protection/economy tips ........5 Your new washer-dryer ..............6 Before washing for the first time ..........8 Preparing and sorting the laundry ..........9 Detergents and Care Products..........11 Programmes.................13 Washing and drying options ..........15 Washing and drying ..............17 Cleaning and care ..............19... -
Page 3: General Safety Information
General safety information – For private domestic use only. Intended use – The washer dryer is suitable for machine washable textiles and hand washable wool and for drying certain types of textiles according to care instructions. – The appliance is suitable for operation with cold mains water and commercially available detergents and care products which are suitable for use in a washer dryer. - Page 4 Warning Safety for children Danger of death! If children play with the washer dryer, they may get into life- threatening situations or injure themselves. – Do not leave children unattended near the washer dryer. – Do not let children play with the washer dryer. Warning Danger of death! Children may lock themselves in appliances, putting their...
-
Page 5: Operation Instructions Environmental Protection/Economy Tips
Environmental protection/economy tips – Separate out the various waste materials of the packaging and take them to the nearest collection point. – Always fill the appliance with a maximum amount of laundry for the relevant programme. – Wash normally soiled laundry without a prewash. –... -
Page 6: Your New Washer-Dryer
Your new washer-dryer The washer-dryer can be used Description of the in 3 ways –> page 17: washer dryer – washing only – drying only – successive washing and drying. The successive wash-dry programme shifts automatically from the wash cycle to the dry cycle without further intervention. Drying is achieved using the condensation principle. - Page 7 Control panel Indicator lamp Display panel Indicate the settings that have been Shows the settings that have been selected (e.g. spin speed, selected for: drying time), the progress of the current programme and the – Temperature: Ž - 90 °C. programme status.
-
Page 8: Before Washing For The First Time
Before washing for the first time The washer-dryer was tested before leaving the factory. To remove any water that may be left over from the test, you should not load any laundry the first time that you run a wash programme. ... -
Page 9: Preparing And Sorting The Laundry
Preparing and sorting the laundry – Wash white laundry separately from coloureds. Sorting laundry for – Unhemmed or torn items should not be washed in the machine, as they may fray. washing – The laundry may be damaged if you do not observe the fabric care symbols. - Page 10 Only dry fabrics that have already been washed, rinsed and spun. Preparing laundry for Also spin easy-care fabrics before drying. Sort the items for washing according to material and desired level of drying dryness to ensure even drying. Before loading the washer-dryer, make sure that there are no foreign Loading the bodies or pets in the drum.
-
Page 11: Detergents And Care Products
Detergents and Care Products The detergent drawer is divided into three compartments Detergent drawer Compartment I : detergent for Pre-wash Compartment II : detergent for Hauptwäsche (Main wash) Compartment i : Liquid additives, such as starch or fabric softener. Additives are automatically dispensed during the final rinse cycle. –... - Page 12 Normally soiled laundry Measuring washing powder Set the programme. Do not select ! Pre-wash –> page 15. Add all the detergent, according to the manufacturer's instructions, to compartment II of the detergent drawer. Heavily soiled laundry Set the programme. ...
-
Page 13: Programmes
Programmes The programme selector is used to set the washing and drying Programme selector programmes. The time remaining until the end of the programme and the recommended load are shown on the display panel. Cottons F (Cottons) Washing programmes* Suitable for hard-wearing fabrics, heat-resistant fabrics made from cotton or linen. - Page 14 Q Shirts/Business Washing programmes* Non-iron shirts made of cotton, linen, synthetic fibres or blended fabrics. Gentle spin only, hang up dripping wet. *depends on the model J Night wash Particularly quiet wash programme with a reduced final spin. Sleep mode. Once the programme has finished, the display goes out, but can be reactivated by pressing any button.
-
Page 15: Washing And Drying Options
Washing and drying options The temperature can be adjusted individually for each programme. Temperature °C button To adjust it, press the °C Temperature button repeatedly until the required temperature is displayed. The spin speed can be individually adjusted for each programme. Spin speed button 0 To set the spin speed, press the 0 Spin button repeatedly until the required spin speed is displayed. - Page 16 The drying programmes –> page 14 can be individually adapted by Drying button S selecting the drying options. – Press the ˆ (Drying) button repeatedly until the required drying option is shown on the display panel. – To deactivate, press the ˆ (Drying) button repeatedly until shown on the display panel.
-
Page 17: Washing And Drying
Washing and drying Turn the programme selector to the desired programme, Washing only e.g. Cottons F (Cottons) 60°C. – B (Remaining time) and the recommended load in kg appear alternately on the display panel. The p (Start/Pause) symbol flashes. ... - Page 18 The washing and drying programmes are ended automatically. End of the programme appears on the display panel. Set the programme selector to Off. Remove the washing from the drum. Leave the door open so that the inside of the washer-dryer can dry out. ...
-
Page 19: Cleaning And Care
Cleaning and care Risk of electric shock Safety information You must disconnect the appliance from the mains first. Never clean the washer-dryer with a water jet. Risk of explosion. Never clean the washer-dryer with solvents. Risk of scalding Hot washing water must be cooled before draining. Wipe with a soft, damp cloth. - Page 20 Drain pump Set the programme selector to Off. Use a screwdriver to release the lock pins. Tip the kick panel and pull upwards to remove. Draining the water Take the drain hose out of the retainer. ...
-
Page 21: What To Do If
What to do if... Risk of electric shock Repairs must only be carried out by customer services or authorised technicians. If repairs are needed, or if you cannot rectify a fault yourself with the help of the following table: Set the programme selector to Off. ... - Page 22 The mains plug is not correctly Plug in the mains plug correctly. Water is not flowing in. plugged in. The door is not properly Close the door. closed. The tap is not turned on. Turn on the tap. The filter in the water supply hose is Clean the filter in the water supply hose blocked.
- Page 23 No fault "Thermo spin", which is for energy-effi- Spinning during drying cient drying, starts after a drying time of approx. 10 minutes. The laundry clings to the sides of the Loosen up the laundry by hand, Drying result not drum after being spun. start the drying programme satisfactory.
-
Page 24: After-Sales Service
After-sales service Before you call the after-sales service, please check whether you can correct the fault yourself –> page 21. You will be charged if a technician is called out, even during the warranty period. You can find information about your nearest after-sales service here or in the After-sales service directory (depending on the model). -
Page 25: Installation Instructions
Installation instructions The washer-dryer is very heavy. Take care when lifting it. Safety information Do not operate the washer-dryer if it has any visible damage. If you are in any doubt, please consult our after-sales service or your retailer. Do not install the washer-dryer outdoors or in areas exposed to frost. Frozen hoses can crack or burst. - Page 26 Removing the transport safety bolts Unscrew all screws using Remove all transport safety bolts completely the spanner supplied and take the mains cable out of the retainers. – Before using the appliance for the first time, you must make sure that all transport safety bolts have been removed and kept safe for any subsequent transport.
- Page 27 Intense noise, vibrations and “wandering” may be the result of incorrect Levelling levelling. – All four appliance feet must be firmly on the ground. – The washing machine must not wobble. – Check the alignment of the washing machine with a spirit level and adjust if necessary.
- Page 28 To prevent leaks or water damage, you must observe the instructions in Water connection this section. If in doubt, have a technician connect the appliance. The water supply and drain hoses can be routed to the left of right, depending on installation conditions. Do not use a used inlet hose.
- Page 29 The washer-dryer must only be connected to an alternating current supply Electrical connection via a properly installed earthed socket. If a residual current circuit breaker is used, only use a type which displays this symbol ‚. Only this symbol guarantees compliance with the currently applicable regulations The mains voltage must match the voltage specifications on the washer- dryer (rating plate).
-
Page 31: Appendix Consumption Rates
Consumption rates Washing Programme Load Energy** Water** Programme duration** Cottons F 40 °C 0.83 kWh 62 l 1:51 h Cottons F 90 °C 2.30 kWh 70 l 2:45 h 7 kg Cottons Eco y 60 °C* 0.85 kWh 54 l 2:30 h = ;... - Page 32 Gaggenau Hausgeräte GmbH Carl-Wery-Straße 34 D-81739 München www.gaggenau.com To book an engineer visit and product advice Please find the contact data of all countries in the enclosed customer service list.