Do you have a question about the FoCol A30 Arc and is the answer not in the manual?
Questions and answers
Summary of Contents for MIRAN FoCol A30 Arc
Page 1
FoCol Carefully read the contents of these instructions, as the instructions indicate the correct step by step procedure to assemble the product. The carton contents page(s) will identify the assembly part numbers and their descriptions. Before proceeding with the assembly process, match the carton contents to the stated contents to ensure there are no missing parts.
Page 3
FoCol • Kits FINISHED END KIT CONTENTS TRANSITION KIT CONTENTS (3) brackets (top, (3) brackets (top, middle, & bottom) middle, & bottom) (2) finished end pieces (2) felt slat (1) bottom support NOTE: E60 FINISHED END KIT AND T60 TRANSITION KIT SHOWN. 323075IS 03-07-2022 SHEET 3 OF 14...
Page 4
FoCol • Hardware 1/4-20 X 1-1/4” HEX HEAD 1/4-20 X 5/8” HEX HEAD SCREW-BLACK SCREW-BLACK 323075IS 03-07-2022 SHEET 4 OF 14...
Page 5
FoCol • Attaching/Detaching Felt Slat Detach upper felt flap from magnet. Lift felt slat straight up to detach from bracket. To reattach felt, slide slat into slotted brackets and reattach top and bottom flaps to magnets. Detach lower felt flap from magnet.
Page 6
FoCol • Attaching an Arc Remove felt slat from back end of arc. REFER TO SHEET 5 Remove (6) screws from right side and set wood fin aside. 323075IS 03-07-2022 SHEET 6 OF 14...
Page 7
FoCol • Attaching an Arc Reapply felt slats to arcs. Use dowels to align arcs to REFER TO SHEET 5 wood fin. Attach from the right side using previously removed screws. 323075IS 03-07-2022 SHEET 7 OF 14...
Page 8
FoCol • Attaching an Arc Continue to attach appropriate arcs to build desired FoCol configurations using previous steps. 323075IS 03-07-2022 SHEET 8 OF 14...
Page 9
FoCol • Attaching Finished Ends Attach finished end with felt using the 1 1/4” screws from the end of the arc. Attach single finished end from kit using provided 5/8” screws. Remove end felt slat from brackets. REFER TO SHEET 5 323075IS 03-07-2022 SHEET 9 OF 14...
Page 10
FoCol • Attaching Finished Ends Reapply felt slats to arcs. REFER TO SHEET 5 323075IS 03-07-2022 SHEET 10 OF 14...
Page 11
FoCol • Attaching Transition Kit to Change Arc Direction *USE WHEN CHANGING DIRECTION OF ARC Remove end felt slat Remove brackets from arc end and from end piece. replace with brackets from transition kit. Transition brackets will need to be rotated REFER TO SHEET 5 180 degrees to create direction change.
Page 12
FoCol • Attaching Transition Kit to Change Arc Direction *USE WHEN CHANGING DIRECTION OF ARC Screw transition brackets into conjoining bracket weld nuts. If weld nuts are not present in conjoining bracket, use provided nuts to fasten. 323075IS 03-07-2022 SHEET 12 OF 14...
Page 13
FoCol • Attaching Transition Kit to Change Arc Direction EXAMPLE OF GROUP FOCOL SHOWING MULTIPLE TRANSITIONS IN GREY 323075IS 03-07-2022 SHEET 13 OF 14...
Need help?
Do you have a question about the FoCol A30 Arc and is the answer not in the manual?
Questions and answers