Table of Contents
Advertisement
4.4.4 Connecting the water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa).
It is necessary to have 10 – 80 litres of water flowing from the fully open tap in one minute
to have your machine run smoothly. Attach a pressure reducing valve if the water pressure is
higher.
A
CAUTION:
In such a case the laundry will get damaged or the product will switch to protection mode and
will not operate.
CAUTION:
stains on your laundry.
1
Tighten the nuts of the hose by hand. Never use a tool when tightening the nuts.
2
When hose connection is completed, check whether there are no leak problems at the
connection points by opening the taps fully. If any leaks occur, turn off the tap and
remove the nut. Retighten the nut carefully after checking the seal. In order to prevent
the water leaks and resultant damages, keep the taps closed when you do not use the
product.
4.4.5 Connecting the drain hose to the drain
• Attach the end of the drain hose directly to the waste water drain, lavatory or bathtub.
A
CAUTION:
water discharge. Moreover, there is risk of scalding due to high washing temperatures! In
order to prevent such situations and make sure that the machine performs water intake and
discharge processes without any problem, fix the drain hose securely.
• Connect the drain hose to a minimum height of 40 cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on the floor level or close to the ground
(less than 40 cm above the ground), water discharge becomes more difficult and the
laundry may come out excessively wet. Therefore, follow the heights described in the
figure.
14 / EN
Models with a single water inlet should not be connected to the hot water tap.
Do not use old or used water inlet hoses on the new product. It may cause
Your drain house will be flooded if the hose comes out of its housing during
Washing Machine /User's Manual
Advertisement
Table of Contents
