System Login; Changing Login Password - Furukawa LW3008C User Manual

4.1.1

System Login

After installing the LW3008C, finally make sure that each port is correctly connected to PC
for network and management. Then, turn on the power and boot the system as follows.
Step 1 When you turn on the switch, booting will be automatically started and login prompt will be
displayed.
SWITCH login:
When you enter a login ID at the login prompt, the password prompt will be displayed, and
Step 2
then enter the proper password to log in the system. By default setting, the login ID is
configured as admin with no password.
SWITCH login: admin
Password:
SWITCH>
In Privileged EXEC View mode, you can check only the configuration for the switch. To
Step 3
configure and manage the switch, you should begin Privileged EXEC Enable mode. The
following is an example of beginning Privileged EXEC Enable mode.
SWITCH> enable
SWITCH#
4.1.2

Changing Login Password

To configure a password for created account, use the following command.
Command
passwd [NAME]
The following is an example of changing the current password.
SWITCH(config)# passwd
Changing password for admin
Enter the new password (minimum of 8, maximum of 16 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password:junior95
Re-enter new password:junior95
Password changed.
SWITCH(config)#
The password you are entering will not be shown in the screen, so please be careful
!
not to make a mistake.The password must be from 8 to 16 characters.
Mode
Global Configures a password for created account.
Description
42