1. Manuals
  2. Brands
  3. Vixen Horns Manuals
  4. Horn
  5. VXO8210
  6. Installation manual

Vixen Horns VXO8210 Installation Manual

Hide thumbs
1
2
3
4
Table of Contents

Advertisement

Quick Links

Download this manual
BEFORE BEGINNING YOUR INSTALLATION
Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.

CONTENTS

 1 Gallon Air Tank
 150 PSI Air Compressor
 150 PSI Air Pressure Gauge
 90-115 PSI Pressure Switch
 Brass Drain Nut
 1/4" NPT Compression Fitting for 1/4" OD Air Line
 1/4" OD Nylon Plastic Hose (6 Feet)
 30A In-line Fuse with Waterproof Holder
 Mounting Hardware
The specific voltage requirement for this on-board air system is 12 volt DC, therefore installation must be done to
a DC power source of 12 volts.

SAFETY INSTRUCTIONS

 Do not attempt to disassemble, repair or customize this product.
 Avoid setting up any parts of this product where there is a risk of falling off or risk of coming in contact with water.
 Avoid reaching out to touch or pick up any fallen or water submerged parts.
 Never leave this product unattended during use.
 Intended for use by adults only.
 During and immediately after use, avoid touching any part of the compressor with bare hands as it is very hot
during such periods.
PAGE 1 of 4
VXO8210
INSTALLATION GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VXO8210 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Vixen Horns VXO8210

Summary of Contents for Vixen Horns VXO8210

  • Page 1 VXO8210 INSTALLATION GUIDE BEFORE BEGINNING YOUR INSTALLATION Read through the instruction guide before getting started with the installation. Professional installation is recommended for this product. CONTENTS  1 Gallon Air Tank  150 PSI Air Compressor  150 PSI Air Pressure Gauge ...
  • Page 2 VXO8210 INSTALLATION GUIDE  Avoid use of product near flames, explosive materials, aerosol products or oxygen devices.  Be sure to pump nothing other than atmospheric air.  It is important to determine the maximum air pressure for any tool or attachment before using it.
  • Page 3 VXO8210 INSTALLATION GUIDE ELECTRICAL CONNECTION ON-BOARD AIR SYSTEM  The red wire of the on-board system coming from the pressure switch should be connected using the provided fuse to (+) 12-volt power source. IMPORTANT: To prevent the compressor from over running and possible damage due to an air leak, connect the compressor’s red wire to a power source in the vehicle that...
  • Page 4 VXO8210 INSTALLATION GUIDE SOLUTIONS TO COMMON ISSUES Issue: Compressor inoperable. Solution 1: Check all switches to make sure they are ON. Solution 2: Check the fuse; if blown, disconnect compressor from power and replace the fuse. Solution 3: Allow compressor to cool off for 30-60 minutes.

Table of Contents