Page 1
The maximum leg spacing is 12 in. (304.8mm). All 100 series Contour Probes come equipped with a 10’ (3.048 m) power cord. The B100 is for use on 115 VAC 60 Hz, single phase grounded power source. Using an approved GFCI is recommended.
Page 2
GENERAL SAFETY RULES Please read all instructions. Failure to follow all instructions listed below may result in injury. If the equipment is used in a manner other than as specified in these operating instructions, the protection provided by the equipment may be impaired. Always wear eye protection. DO NOT OPERATE unit from a DC power source.
Page 3
OPERATION: Connect the instrument plug into a Grounded power outlet of proper voltage. Place the Contour Probe legs upon the work surface with the suspected defect at right angles to the legs (Good contact will produce the best results). Push the test switch to energize the instrument.
Page 4
ALWAYS WEAR SAFETY GLASSES WHEN USING THIS EQUIPMENT PARKER RESEARCH CORP. 2642 ENTERPRISE ROAD WEST CLEARWATER, FL 33763...