Table of Contents
Advertisement
Engine-Speed Switch
The engine-speed switch
change the engine speed. Tap the switch to increase
or decrease the engine speed in 100 rpm increments.
Hold down the switch to automatically move to High
or Low idle, depending on which end of the switch
you press.
PTO Switch
The PTO switch has 2 positions: O
I
(
). Pull the PTO button out to engage the
N
STOP
cutting-unit blades. Push the button in to disengage
the cutting-unit blades
High-Low Speed Control
The switch
(Figure
11) allows the speed range to
increase for transporting the machine. To switch
between the High and Low speed ranges, raise the
cutting units, disengage the PTO and the cruise
control, put the traction pedal into the N
position, and move the machine at a slow speed.
Note:
The cutting units do not operate and/or cannot
be lowered from the transport position when the
switch is in the high range.
Cruise-Control Switch
The cruise-control switch locks in the pedal position
to maintain the desired ground speed
Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the
cruise-control function, and the front of the switch sets
the desired ground speed.
Note:
Pressing either brake pedal or moving the
traction pedal into the reverse position, for 1 second,
also disengages the pedal position.
Lift Switches
The lift switches raise and lower the cutting units
(Figure
11). Press the switches forward to lower the
cutting units and rearward to raise the cutting units.
When starting the machine, with the cutting units in
the down position, press the lift switch down to allow
the cutting units to float and mow.
Note:
The cutting units do not lower while in the
high-speed range and they do not raise or lower if you
are out of the seat while the engine is running. Also,
the cutting units lower with the key in the O
and you are in the seat.
Light Switch
Press the light switch upward to turn the lights to the
O
position
(Figure
11).
N
(Figure
11) has 2 modes to
(
) and
UT
START
(Figure
11).
EUTRAL
(Figure
position
N
Press the light switch downward to turn the lights to
the O
position.
FF
Power Point
Use the power point
12 V electrical accessories.
1. Power point
Bag Holder
11).
Use the bag holder for storage
Seat Adjustments
Seat-Adjustment Lever
Move the seat adjustment lever on the side of the
seat outward, slide the seat to the desired position,
and release the lever to lock the seat into position
(Figure
14).
17
(Figure
13) to power optional
Figure 13
2. Bag holder
(Figure
13).
g036845
Advertisement
Table of Contents
