Advertisement
RC4 LumenDimMIO-100 Quick Start Guide
May-2023 / Rev1
The LumenDimIO-100 uses a genuine LumenRadio TimoTwo RF module. This device supports Bluetooth connectivity
with the LumenRadio CRMX Toolbox app on a smartphone, which is the easiest and most intuitive way to configure the
LumenDimIO-100.
For Apple iOS, search for the CRMX Toolbox in the App Store.
For Android, search for the CRMX Toolbox in Google Play.
Download and install the app. It is provided at no charge, does not use advertising, and does not collect any personal
information. It is a safe and secure application.
Use CRMX Toolbox to:
●
set the LumenDimIO-100 as a transmitter (TX) or receiver (TX)
●
set a Linking Key if desired
●
set the RF output power (to a maximum of 100mW)
The Link button is recessed under a slotted opening below the DC power input receptacle. Use a small screwdriver or
bent paperclip to press it.
TO LINK:
1. Power on the CRMX devices you would like to connect.
2. Configure the LumenDimIO-100 for RX (receiver) or TX (transmitter) mode using either the CRMX Toolbox app,
or see instructions below.
3. Ensure that the Status LED indicators on all receivers are off to indicate that the receivers are ready to be
linked. (If necessary, follow the unlink procedure below.)
4. On the transmitter, press and release the Link button.
5. The transmitter will search for any unlinked receivers. Its Status indicator will flash for 10 seconds, then normal
operation will resume.
6. The Status indicator will display short blinks in the selected universe color on successfully linked receivers.
TO UNLINK:
Unlink one receiver device:
●
On the receiver, press and hold its link button for more than 3 seconds to unlink it from a transmitter. The
Status indicator will turn off.
Unlink all from transmitter:
●
On the transmitter, press and hold its link button for more than 3 seconds to unlink all of its receivers.
Soundsculpture Incorporated • 13604 Heathwood Court, Raleigh, NC 27615 USA
Toll free 1-866-258-4577 • www.theatrewireless.com
Advertisement
Table of Contents
Related Manuals for RC4 LumenDimMIO-100
Summary of Contents for RC4 LumenDimMIO-100
- Page 1 RC4 LumenDimMIO-100 Quick Start Guide May-2023 / Rev1 The LumenDimIO-100 uses a genuine LumenRadio TimoTwo RF module. This device supports Bluetooth connectivity with the LumenRadio CRMX Toolbox app on a smartphone, which is the easiest and most intuitive way to configure the LumenDimIO-100.
- Page 2 The most commonly used LumenDimIO-100 functions can be selected using the Link button, so you can access them without a smartphone. Patterns of short and long button pushes are used. A short push is less than half a second. A long push is more than 3 seconds.
Need help?
Do you have a question about the LumenDimMIO-100 and is the answer not in the manual?
Questions and answers