Advertisement
FF
HS/2 Series LED lood Light
Optional Slip Fitter
1
The Optional Slip Fitter mount AC-FHS-SF provides a tilt option for the FFHS/2
Luminaire. There are several sizes for the FFHS/2 Series. The AC-FHS-SFS is for
the FFHS/2-400/500 Luminaire. The AC-FHS-SFM is for the FFHS/2-600/750
Luminaire. The AC-FHS-SFL is for the FFHS/2-1000/1200 Luminaire. Align the
Slip Fitter to the FFHS/2 Handle and fasten the two pieces together using the
[4] Hex Head Bolts and nuts.
with the Slip Fitter to the pole, if needed, adjust
directly at the Slip Fitter by removing the Phillips
head screws, the cover, loosening the bolt with
a wrench, and pulling slightly to move the parts
freely from the teeth. After adjusting the Slip
Fitter tilt, mate the parts at the teeth and fasten
the bolt, put the cover in place, install the screws.
Need help? Tech help line: (800) 988-6386 Email: cs@paclights.com Website: www.paclights.com
Copyright © 2021 PacLights
F
2
Once the Slip Fitter is properly
secured onto the FFHS/2 Fixture,
one can then run the Power Cable
from the Fixture to the inside of the
pole to allow it to be powered with
an AC Power Supply Cable. Follow
the wiring diagram. One can then
place the Slip Fitter on top of a
standard 2 3/8" diameter pole, adjust
the orientation and fasten the [4] Hex
Head Bolts to secure the Slip Fitter
to the pole.
3
After properly securing the FFHS/2 Luminaire
All Rights Reserved
Installation Sheet
Optional Glare Shield
1
The Optional Glare Shield AC-FHS-GS provides a restriction for excess glare by
the FFHS/2 Luminaire. There are several Glare Shields for the FFHS/2 Series. The
AC-FHS-GSS is for the FFHS/2-400/500 Luminaire, the AC-FHS-GSM is for the
FFHS/2-600/750 Luminaire, and the AC-FHS-GSL is for the FFHS/2-1000/1200
Luminaire. The Glare Shield restricts the amount of light pollution and light trespass.
2
Align the Glare Shield to the front of
the FFHS/2 fixture holes along the rim.
Fasten the Glare Shield to the fixture
with the [5] Socket Head Cap screws.
Optional Photo Cell
The FFHS/2 Series have an Optional Photo Cell that can be attached to the Junction
Box at the side. The Photo Cell has three wires: Neutral [White], Hot [Black], and
Hot [Red]. The Neutral [White] attaches inline with the Power Supply and Fixture
ACN Neutral [Blue/White] wires. The Photo Cell has an internal 'switch' with a Hot
[Black] wire that attaches to the Power Supply Hot [Black] and a Hot [Red] wire that
attaches to the Fixture ACL [Brown/Black] wire. Mounting is recommended in the
upright position. Please follow the wiring diagram as shown.
JUNCTION BOX
AC Power Supply
HOT [BLACK]
NEUTRAL [WHITE]
HOT [RED]
Note: Instructions are subject to change at any time without notice
PHOTO CELL
FFHS/2 FIXTURE
HOT [BLACK]
HOT [RED]
ACL [
BROWN
NEUTRAL [WHITE]
ACN [
BLUE
G
ROUND [
/BLACK]
/WHITE]
GREEN
]
Page 2 of 2
02-00036-211214
Advertisement
