LEGRAND NUVO P10 Product Manual page 9

Figure 1
Navigate to the SETTINGS menu by pressing the gear icon at the bottom of the app home page.
1.
Select Add a component.
2.
Select Keypad (See Figure 1).
3.
Look for the component LEDs to have a breathing motion (See Figure 2).
4.
NOTE: A breathing motion is a rolling flash. The LED slowly rolls from on to off over 2–3 seconds.
• If the LEDs are not breathing, select The LED's are not breathing at the bottom of the screen. Follow the
instructions on the screen (See Figure 3).
• If the LEDs are breathing, select Next (See Figure 2).
Press the Volume up and Mute buttons simultaneously to initiate the binding process (See Figure 4).
5.
If the component fails to connect, confirm that the device is powered on and has an Ethernet connection to the
same network as the mobile device running the Nuvo Player app (See Figure 5).
Figure 6
Select the zone for the component to control (See Figure 6).
6.
Once the connection is successful, "Keypad added" displays on the screen along with the associated zone
7.
(See Figure 7). The screen shows the connection in the keypad settings (See Figure 8). Select Done to return to
the SETTINGS screen. If all keypads have been added, return to the HOME screen.
NOTE: Up to four keypads can be assigned to a single zone.
IMPORTANT: After setup, if it is necessary to reset your P10‑XX or P20‑XX to factory default settings, press the Volume up and Volume down buttons simultaneously.
Hold for 10 seconds. Release the buttons when the LEDs begin flashing.
Player Portfolio Audio System | Product Manual
Figure 2 Figure 3
Figure 7 Figure 8
Figure 4 Figure 5
9