Maintenance; Troubleshooting - Briggs & Stratton 1696893 Operator's Manual

Maintenance

Periodically check the pole saw for misalignment, binding
of moving parts, breakage of parts and any other condition
that may affect the pole saw operation. If damaged, have
the unit repaired before use.
Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
All maintenance, repair and inspection work should be
performed by an authorized service center.
Maintenance Chart
Refer to the following table for routine maintenance.
Requirements Actions
Visual inspection
Cutting
Inspect and
System
check assembly
Check
All accessible
fasteners
Retighten

Troubleshooting

The following chart lists problems, causes and corrective
actions if your pole saw does not operate properly. If these
do not correct the problem, contact an authorized service
center.
Problem
Motor runs but
blades remain
stationary
Cutting tool too hot
Excessive vibration
After
Before
start
finish
• •
•
•
• •
Possible Cause
Drive cables not engaged.
Dull cutting blades.
Blades out of alignment.
Too much friction.
Loose fasteners.
Correction
Disconnect the poles; make sure the drive cables engage
as poles are connected.
Contact an authorized service center.
Contact and authorized service center.
Apply lubricant to the blades.
Tighten fasteners.
en 5