Maintenance; Technical Data - Quick THRUSTER COMMAND TCD 1022 E Manual For Use And Installation

SYSTEM PROBLEMS - MAINTENANCE - TECHNICAL DATA
N. OF
PROBLEM
FLASHES
1 Overload on the
command electrical
line
2 Interruption on the
command electrical
line
3 Problem present on
the BTR* propeller.
4 Problem present in the
parallel/series switch*
5 Problem present on
TMS*
* If installed.
The resetting of this class of problems occurs, once the cause that has generated them has been removed, by switching off and
switching back on the remote control.
When problems 3, 4, 5 are present, it may be necessary to turn off and turn back on the external devices that signalled the pro-
blem. Refer to their installation and use manual.

MAINTENANCE

The control panel needs no particular maintenance. To ensure optimum performance from the equipment, once a year check the
cables and the electrical connections.
Clean the control panel with a soft cloth dampened with water. Do not use chemical or abrasive products to clean the control
panel.

TECHNICAL DATA

MODEL
OUTPUT CHARACTERISTICS
Current capacity of right or left thruster
commands.
INPUT CHARACTERISTICS
Supply voltage (1)
Quiescent current (2)
Maximum current absorption (3)
AMBIENT CHARACTERISTICS
Operating temperature
Protection rating (4)
GENERAL CHARACTERISTICS
Dimensions including frame (L x L)
Weight
EMC class
(1) With power supply voltage less than 8 Vdc the control panel can reset.
(2) Typical value with control panel disabled.
(3) Typical value with control panel enabled and one direction button pressed.
(4) Excluding the back of the control panel (IP20).
®
QUICK RESERVES THE RIGHT TO MODIFY THE TECHNICAL CHARACTERISTICS OF THE EQUIPMENT AND THE CONTENTS OF THIS MANUAL WITHOUT PRIOR NOTICE.
TCD1022 E / 1042 E - REV005A
DESCRIPTION
The problem is signalled when the control detects a short circuit or an overload on the command
electrical line of the propeller. Check the wiring of the electrical line of the remote control to
the propeller and the absorption of the remote control switches installed on the propeller.
The problem is signalled when the control detects an interruption on the command electrical
line of the propeller.
Check the wiring of the electrical line of the remote control to the propeller.
The control system of the BTR propeller has detected a problem.
Refer to the BTR use and maintenance manual.
The control system of the PSS switch has detected a problem. Refer to the PSS use and
maintenance manual.
The TMS line switch has detected a problem connected to the remote control switch of the
propeller. Refer to the TMS use and maintenance manual.
TCD 1022
78 mm x 78 mm
80 g
EN 60945 - FCC TITLE 47 Part 15 SUBPART B CLASS B
4A max
from 8 to 31 Vdc
10 mA
55 mA + absorption of remote control coil
from -20 to +70 °C
IP 66
EN
TCD 1042
78 mm x 78 mm
140 g
23