Larson Electronics SLEDB-110V-DNS-20C Series Quick Start Manual

Class II Strobe Light with Day/Night Sensor - 110-120V AC - 54
Flashes Per Minute - 5 Color Options - 20' 16/2 SOOW
Thank you for your purchase of the Larson Electronics SLEDB-110V-DNS-20C series Strobe Light with Day/Night
Sensor and 20' 16/2 SOOW cord. This strobe light is completely assembled, tested and ready for installation when
shipped from the factory. Please follow the steps below in order to operate and maintain this product.
IMPORTANT
READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. IF UNSURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICAL
PROFESSIONAL.
WARNING:
OPERATE ONLY AT THE VOLTAGE LISTED ON THE PRODUCT. DO NOT OPERATE IN CLOSE
PROXIMITY OF COMBUSTIBLE OR FLAMMABLE MATERIALS. NEVER LOOK DIRECTLY AT LIGHT WHEN ON.
WARNING:
CONSULT A QUALIFIED ELECTRICAL PROFESSIONAL/ELECTRICIAN TO INSTALL THIS DEVICE IN
ACCORDANCE WITH APPROPRIATE LOCAL AND NEC CODES AND REGULATIONS.
WARNING:
TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE ELECTRICAL CODES
AND REGULATIONS.
WARNING:
DEVICE
RECOMMENDED.
WARNING:
ALTHOUGH FIXTURE IS WATERPROOF, IT IS NOT DESIGNED OR INTENDED TO BE SUBMERGED.
WARNING:
DO NOT ALLOW LINE VOLTAGE WIRES TO BECOME SUBMERGED!
•
ALL OUTDOOR INSTALLATIONS AND INDOOR INSTALLATIONS NEAR A WET LOCATION REQUIRE THE
USE OF A GFCI DEVICE FOR SAFETY, ACCORDING TO THE NATIONAL ELECTRICAL CODE® (NEC).
•
KEEP AWAY FROM FLAMMABLE OBJECTS. DO NOT POSITION WITHIN ONE (1) INCH OF ANY
COMBUSTIBLE MATERIALS.
•
IF DROPPED OR DAMAGED, THE UNIT MAY NO LONGER BE WATERPROOF AND SHOULD BE
REPLACED.
•
TO AVOID HAZARDS TO CHILDREN, ACCOUNT FOR ALL PARTS AND DESTROY PACKING MATERIALS.
INSTALLATION
This unit comes pre-assembled with the selected color from factory. Follow the steps below for installing and
maintaining the strobe light.
MOUNTING
Mount to any flat surface capable of holding the weight utilizing the predrilled
mounting holes. Mount in any direction as long as the day/night sensor can still
detect light levels.
WIRING
We strongly encourage a licensed electrician install this product, especially in outdoor locations where
weatherproofing may be required. Voltage driver permits operation at
Warning: Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture
wires as shown in the diagram
Take precautionary
connections if installed in a location where water may
come in contact with the unit. Ensure the unit is properly
grounded.
Larson Electronics, LLC
IS SUITABLE FOR
steps for weatherproofing
Phone: (800) 369-6671
INSTALLATION IN WET
110-120V AC
all
Fax: (903) 498-3364
SLEDB-110V-DNS-20C
LOCATIONS; GFCI PROTECTION
.
www.larsonelectronics.com
1 of 2