Maintenance And Storage - Gardif LK 41 B&S Original Instruction Manual

grass, and when transporting the lawn mower to and from the area to be mowed;

Never operate the lawn mower with defective guards, or without safety devices, for example
deflectors and/or grass catchers, in place;

Disengage all blade and drive clutches before starting the engine;

Start the engine carefully according to instructions and with feet well away from the blade(s);

Do not tilt the lawn mower when starting the engine;

Do not start the engine when standing in front of the discharge chute;

Do not put hands or feet near or under rotating parts. Do not touch rotating blade.

Keep clear of the discharge opening at all times;

Never pick up or carry a lawn mower while the engine is running;

If the the machine should start vibrating abnormally, stop the engine and visually inspect the cutting
mechanism to ensure it is in good condition. Vibration is usually a warning sign for trouble. A damaged
cutting blade must be replaced immediately with a new replacement blade

The engine and exhaust of the lawnmower become hot while running and can cause a burn. Ensure
these are not touched.
Stop the engine and disconnect the spark plug wire, make sure that all moving
parts have come to a complete stop and, where a key is fitted remove the key:
- Before clearing blockages or unclogging chute;
- Before checking, cleaning or working on the lawn mower;
- After striking a foreign object. Inspect the lawnmower for damage and make repairs before restarting and
operating the lawn mower;
- If lawn mower starts to vibrate abnormally (check immediately);
Stop the engine and disconnect the spark plug wire, make sure that all moving
parts have come to a complete stop and, where a key is fitted remove the key:
- Whenever you leave the lawn mower;
- Before refueling;

Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve,
turn the fuel off at the conclusion of mowing ;

Go slow when using a trailing seat ;

Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition;

Never store the equipment with petrol in the tank inside a building where fumes can reach an open
flame or spark;

Allow the engine to cool before storing in any enclosure;

To reduce the fire hazard, keep the engine, silencer, exhaust, battery compartment and petrol storage
area free of grass, leaves, or excessive grease;

Check the grass catcher frequently for wear or deterioration;

Replace worn or damaged parts for safety; Only use original spare parts

Blade sharpening and balancing including relative dismantling and re-assembly are complicated
operations which involves specific competence as well as special equipment. For safety reasons, these
operations must be carried out by a specialized technical assistance center. The same procedure
applies for blade replacement.

The cutting edges of the mower blade are sharp and can lacerate (cut) skin tissue. Care should be
taken when doing any repair work on or around the mower blade.

If the fuel tank has to be drained, this should be done outdoors.

MAINTENANCE AND STORAGE

6