AEG HKP87420FB User Manual page 13

Place the cookware with the bottom
diameter larger then 160 mm centrally
between two sections.
5.2 FlexiBridge Standard
mode
This mode is active when you activate
the hob. It connects the sections into two
separate cooking zones. The sides of the
zones which operate together in this
mode light up, and they are linked with
shorter illuminated lines. You can set the
heat setting for each zone separately.
Use two left side control bars.
Correct cookware position:
125-160mm
> 160 mm
Incorrect cookware position:
5.3 FlexiBridge Big Bridge
mode
To activate the mode press
see the correct mode indicator . This
mode connects three rear sections into
one cooking zone. The one front section
is not connected and operates as a
separate cooking zone. You can set the
heat setting for each zone separately. To
set the heat setting use the two control
bars on the left side. Use the right
control bar for the bigger zone and the
left control bar for the smaller zone.
Correct cookware position:
To use this mode you have to place the
cookware on the three connected
sections. If you use cookware smaller
than two sections the display shows
and after 2 minutes the zone switches off.
ENGLISH 13
until you