Dimplex OCR15TIF Instruction Manual page 9

Operation
Thermostat
The Thermostat, see Fig.2 controls the heat output according to the room temperature.
This ensures that the heater will not produce heat unnecessarily when the room is
warm.
1. To set the temperature you require, turn the thermostat knob clockwise until the
required setting is reached. Alternatively to heat a cold room quickly, turn the
thermostat knob up fully.
2. When the room has reached the desired temperature, turn the thermostat knob
anti-clockwise until the thermostat just clicks off. The heater will now automatically
operate at this temperature.
3. The thermostat also has a frost protection setting marked '
in areas such as garages, to prevent frost damage. If the thermostat is set to its
minimum setting '
approximately 5° to help protect against frost.
Note – Should the heater fail to come on when the thermostat is at a low setting, this
may be due to the room temperature being higher than the thermostat setting.
Heat Selector Switches (see Fig.3)
Heat selection is provided via a rotary switch offering four settings. The heat output
can be altered to suit the application, conditions and for improve the economy of
operation.
Available output options are as follows:
Model
O
0CR15FA Off
OCF15TIF
Off
OCR24FA
Off
OCR24TIF
Off
*
' the heater will cycle on and off to maintain a temperature of
Switch setting
I II III
500W 700W 1200W
500W 700W 1200W
900W 1200W 2100W
900W 1200W 2100W
*
' This setting is useful
With Only
Turbo Turbo
ON ON
1500W 300W
1500W 300W
2400W 300W
2400W 300W
9