ECAM Plus KP2 Quick Start Installation Manual

QUICK START INSTALLATION GUIDE
FOR KP2 VIDEO TELEMATICS CAMERA
Standard Kit (w/Optional OBDII Data Adapter Cable)
A.
1. Review the package contents.
2. Scan the QR code inside the box
for a detailed installation video, spec
sheet and user guide.
6. Remove adhesive and apply cable
clips to windshield. Slide the bracket
power cable into clips.
10. Turn on your vehicle. Check
that both blue and green lights
remain on after 5 minutes. If not,
an error occurred.
C.
B.
D.
3. Watch the installation video.
Refer to proper camera installation
guidelines here.
7. Tuck cable behind weather stripping,
and push stripping in to secure it.
11. Scan the QR code above, and
download the iOS or Android KP2
installation app.
A. KP2 Camera, Mounting
E.
Bracket and Attached
Bracket Power Cable
B. 3M ™ Adhesive Tape
C. Alcohol Pads
D. Clips
E. Torx ® Wrench
F. Optional: OBDII
F.
Data Adapter Cable
(Connects to A) -
Sold Separately
4. Use wipe to clean the window.
Allow time to dry. To determine
compliant device placement,
check local regulations.
8. At the end of the bracket cable (A),
connect the terminal to the smaller
end of the adapter cable (F).
12. Open the KP2 installation app, and
scan the IMEI code on the box's label.
Proceed to next page for
Use the appropriate QR code to
download the KP2 Installation App.
5. Remove backing. Press evenly
to ensure the mounting bracket's
adhesive is flush against the glass.
Hold to window for 30 seconds.
9. Plug the end of the OBDII adapter
cable into your vehicle's OBDII port.
13. Follow the device configuration
prompts to complete the installation
app.
device calibration
>