Summary of Contents for 4B SLIPSWITCH M300
- Page 1 M300 (CSA & ATEX Approved) PROGRAMMABLE UNDERSPEED MONITOR SLIPSWITCH Type M3005V10CA CSA & ATEX APPROVED, SELF CONTAINED UNDERSPEED MONITOR Manual No: M2479 INSTALLATION INSTRUCTIONS TECHNICAL INFORMATION UNDERSPEED MONITOR - M3005V10CA Page 1 of 8...
- Page 2 3. SELECT A QUALIFIED AND COMPETENT INSTALLER Correct installation of the product is important for safety and performance. If you have not asked 4B to perform the installation of the unit on your behalf, it is critical for the safety of your operation and those who may perform work on your operation that you select a qualified and competent electrical installer to undertake the installation.
-
Page 3: Installation
Introduction The SLIPSWITCH series is designed to detect slippage or stoppage on elevators, conveyors, fans etc. The units require no connection with the shaft, have no moving parts and a virtually unlimited life. They incorporate microcontroller circuitry which automatically calibrates to 20% under normal speed and provides a programmable 0- 30 second start up delay. -
Page 4: Dimensions (In Mm)
Apply power to the machine and SLIPSWITCH. Ensure that the machine has reached normal running speed and then place the magnet on the 'Cal' point (located on label on rear of unit), Count flashes of the green LED to set the start delay required in seconds, then remove magnet. - Page 5 Sarl) HEREIN AFTER REFERRED TO AS 4B TO THE ORIGINAL PURCHASER AGAINST DEFECTS IN WORKMANSHIP OR MATERIALS UNDER NORMAL USE FOR ONE (1) YEAR AFTER DATE OF PURCHASE FROM 4B. ANY PRODUCT DETERMINED BY 4B AT ITS SOLE DISCRETION TO BE DEFECTIVE IN MATERIAL OR...
- Page 6 729 Sabrina Drive, East Peoria, Illinois 61611 USA Tel: 309 -698 -5611 Fax: 309-698-5615 e-mail: 4b-usa@go4b.com Web: www.go4b.com 4B BRAIME ELEVATOR COMPONENTS Hunslett Road, Leeds, LS10 1JZ England Tel: +44 (0) 113 246 1800 Fax: +44 (0) 113 243 5021 e-mail: 4b-uk@go4b.com...