Wireless Wan Card And Wireless Wan Card Bracket (For Selected Models) - Lenovo ThinkPad X13 Gen 4 User Manual

Troubleshooting
If the computer does not start up after you reinstall the base cover assembly, disconnect the ac power
adapter and then reconnect it to the computer.
Wireless WAN card and Wireless WAN card bracket (for selected
models)
The following information is only for the computer with user-installable modules. Ensure that you use only a
Lenovo-authorized wireless module specifically tested for this computer model. Otherwise, the computer will
generate an error-code beep sequence when you turn on the computer.
Prerequisite
Before you start, read
Generic Safety and Compliance Notices
Attention: Do not touch the contact edge of the wireless WAN card. Otherwise, the wireless WAN card
might get damaged.
For access, do the following:
1. Disable the built-in battery. See "Disable Fast Startup and the built-in battery" on page 47.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 48.
Removal procedure
Note: A Mylar film might cover the wireless WAN card. To access the wireless WAN card, peel off the film
first.
Type 1:
50
ThinkPad X13 Gen 4 and ThinkPad X13 Yoga Gen 4 User Guide
and print the following instructions.