Nl Originele Handleiding - Hilti NURON NMX 622 Manual

Trouble or fault
The battery runs down more
quickly than usual.
The battery does not engage
with an audible click.
LEDs of the battery show
nothing
The drive spindle doesn't
rotate.
Product or battery gets very
hot.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 Further information
For more information on operation,
qr.hilti.com/manual/?id=2341691&id=2341693
This link is also to be found at the end of the documentation, in the form of a QR code.
Originele handleiding
1 Informatie over documentatie
1.1 Over deze documentatie
• Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
22 Nederlands
Possible cause
Battery state of health is not opti-
mal.
Retaining lug on the battery dirty.
Battery faulty.
Battery not fully inserted.
Spindle locking switch is in the
position.
Electrical fault.
technology, environment and recycling,
Action to be taken
▶ Call up the battery's state of
health. Section headed "Status
indicators of the Li­ion battery"
→ page 17.
▶ Clean the retaining lug and
re-insert the battery.
▶ Contact Hilti Service.
▶ Push the battery in until it
engages with an audible click.
▶ Set the spindle locking switch
to the position.
▶ Immediately switch off the
product. Remove the battery
and keep it under observation.
Allow it to cool down. Contact
Hilti service.
follow this link:
2341691
*2341691*