Page 2
OLED USAGE RM0004-0.96” LCD USAGE 1. Enable i2c1 and set the speed sudo nano /boot/config.txt Add the following command to /boot/config.txt file: dtparam=i2c_arm=on,i2c_arm_baudrate=400000 Save and exit. 2. Add the shutdown function Press the power button and then configure the following script to use the safe shutdown function.
Page 5
EXPLODED VIEW M2.5*5 Round-head Screws SD card adapter LCD sticker USB adapter M3*5 Flat-head screw for SSD M2.5*5 Round-head Screws SD card adapter LCD sticker M3*5 Flat-head screw for SSD Note: The screw holes for mounting the SSD are pre-drilled. No need to fix the screws on both sides, which is also perfect for inserting the SSD tightly into the SATA shield.
INSTALLATION Attach the top panel to the bottom panel...
Page 7
INSTALLATION M3*5 Countersunk Screws Fix the metal housing with M3*5 screws...
Page 8
INSTALLATION M3*5 Countersunk Screws Use M3*5 countersunk screws to fix the side bracket to the housing.
Page 9
INSTALLATION M2.5*5 Round-head Screws M2.5*5 Round-head Screws Fix the LCD display and power button with M2.5*5 round-head screws, then attach the stickers.
Page 10
INSTALLATION Attach the 2.5" SSD to the SATA shield.
Page 11
INSTALLATION SD Card Adapter Connect Pi and SATA shield by SSD adapter...
Page 12
INSTALLATION M2.5*5 Round-head Screws M3*5 Flat-head screw for SSD Note: The screw holes for mounting the SSD are pre-drilled. No need to fix the screws on both sides, which is also perfect for inserting the SSD tightly into the SATA shield. When not installing the SSD, just fix the SATA shield with M2.5*5 round head.
Page 13
INSTALLATION SD Card Adapter Insert the other end of the sd card adapter M2.5*5 into the micro-sd card slot on the back of Round-head the Raspberry Pi. Screws Spring-load pins NOTE: Please pay attention to the Raspberry Pi GPIO1-8 tightly against the yellow spring pin on the SATA shield, otherwise, it may cause no power supply.
Page 14
INSTALLATION Insert the USB adapter, and connect the SATA shield and Pi. OLED Cable Power Button Cable...
Page 15
INSTALLATION Push the 4 installed modules into the enclosure and simply tighten the captive loose-o screws to complete the installation.
Page 16
CONTACT US If any problem, feel free to contact us. Website: www.uctronics.com Email: support@uctronics.com metal...