Advertisement
ADJUSTABLE STAINLESS STEEL BRACKET
REV. 1/17
MODEL 55-0408SS
FOR AUXILIARY OUTBOARDS
UP TO 15 HP
INSTRUCTION MANUAL
Vertical travel : 11 inches [27.9 cm]
Setback up: 8-3/4 inches [22.23 cm]
Setback down: 14 inches [35.56 cm]
Motor Mount Plate dimensions: 11.5 wide x 10.75 high [inches]
Product weight 21 lbs. [9.52 kg]
1.604.940.2010 | sales@cmpgroup.net
BACK VIEW
29.21 wide x 27.31 high [cm]
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CMP Panther 55-0408SS
Summary of Contents for CMP Panther 55-0408SS
- Page 1 MODEL 55-0408SS ADJUSTABLE STAINLESS STEEL BRACKET FOR AUXILIARY OUTBOARDS UP TO 15 HP INSTRUCTION MANUAL BACK VIEW Vertical travel : 11 inches [27.9 cm] Setback up: 8-3/4 inches [22.23 cm] Setback down: 14 inches [35.56 cm] Motor Mount Plate dimensions: 11.5 wide x 10.75 high [inches] 29.21 wide x 27.31 high [cm] Product weight 21 lbs.
- Page 2 4-Stroke Auxiliary Outboard Motor Bracket Mounting and Operating Instructions For the following products only: 55-0407AL, 55-0408SS, 55-0410, 55-0416 AUXILIARY OUTBOARD MOTOR BRACKET CAUTION GUIDELINES 1. Always remove your motor from bracket when trailer- ing. Failure to do so may result in damage to boat, motor, or bracket.
- Page 3 DRAWINGS NOT TO SCALE �nce �ou have �our measurin� s�ck in place� posi�on the outboard motor bracket on the transom of the boat on either the starboard or port side. Care should be exercised to make sure that the bracket will not interfere with the movement of the exis�n� en�ine or a rud� der. ...
- Page 4 Check again to make sure that there are no obstruc�ons on the inside of the transom and then drill four 3/8” holes at the marked loca�ons. �pply a bead of RTV silicone sealant around each hole to ensure a waterproof seal. ��ach the outboard bracket to the transom with 5/16 stainless steel fasteners. For transoms that are 2” or less in thickness a backing plate should be used. �hen �ghtening the locking nuts on the a�achment bolts, there should be at least two threads of the bolts protruding through the nut to insure good locking characteris�cs. NOT TO SCALE Trim adjustment should now be made to insure that the engine’s cavita�on plate is parallel to the bo�om of the boat. �hile standing on either side of the boat, sight down the boat bo�om and compare with the plane of the cavita�on plate. �f adjustment is necessary, try moving the engine’s built‐in trim adjustment pin , it will probably have around �ve posi�ons to try. ...
- Page 5 The warranty coverage on this equipment is limited to the terms set forth below: CMP Group Ltd. warrants this product to be free of defects in material and workmanship for a period of ONE (1) YEAR from the date of original retail purchase. Positive proof of date of purchase is required for warranty service.
Need help?
Do you have a question about the Panther 55-0408SS and is the answer not in the manual?
Questions and answers