Remove The Base Assembly For Vesa Mounting - Philips E Line UltraWide 346E2CUAE/69 User Manual

2. Setting up the monitor
• PIP Position: When PIP is activated,
there are four sub-window positions
to choose.
Top-Left
B
A
(main)
Bottom-Left
A
(main)
B
• Swap:
The main picture source
and the sub picture source
swapped on the display.
Swap A and B source in [PIP] mode:
B
A
(main)
Swap A and B source in [PBP] mode:
A B
(main)
• Off:
Stop MultiView function.
Note
When you do the SWAP function, the
video and its audio source will swap at
the same time.
Top-Right
B
A
(main)
Bottom-Right
A
(main)
B
A
B
↔
(main)
B A
↔
(main)
A
(main)
2.4 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
display base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. While keeping the release button
pressed, tilt the base and slide it
out.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.
12