hospicall Easywave FU2-UMH Manual page 2

Necklace Transmitter FU2-UMH
GB
Models
LED
Transmit button
FU2-UMH 31 20 30
Technical details
Frequency: 868.30 MHz
Radiated
power: 0.11 mW
Modulation: FSK
Coding: Easywave
EasywavePlus
Power supply: 1x 3-V-battery
CR2032
Operating
temperature: -20 °C to +60 °C
Range: free-field: approx. 150 m
buildings: approx. 30 m
Degree of
protection: IP65
Dimensions: Ø 41 mm x 13 mm
Weight: 16 g
Scope of delivery
Necklace transmitter incl. battery,
neckband, operating instruction
Intended use
This necklace transmitter may only be
used to operate Easywave radio cont-
rols.
The manufacturer shall not be liable
for any damage caused by improper or
non-intended use.
Safety advice
Do not make any unautho-
rized alterations or modifica-
tions to the transmitter!
Note also the operating instructions of
the radio receivers!
Keep the transmitter away from child-
ren!
Have faulty devices checked by the
manufacturer!
Keep the batteries out of the reach of
children!
Start-up
Attach the neckband to the transmitter.
Transfer the transmission code to the
radio receiver.
For this read the operating instruction
supplied with the radio receiver.
Operating the transmitter
Press the transmission button. The
transmitter's LED lights up. The trans-
mitter transmits as long as the button is
pressed.
After max. 36 seconds, the transmission
process is stopped automatically. Press
the transmit button again to repeat the
transmission process.
Battery check
The transmitter has a battery check
function, which monitors the capacity of
the battery cyclically.
If the battery is weak, the LED flashes
for about 3 seconds after releasing the
transmitter button. Please replace the
battery now.
Replacing the battery
We recommend having the battery re-
placed by your retailer.
For exchanging the battery please use
the key ACC-TOO-01.
Trouble shooting
- If the LED does not light up at all: ex-
change the battery or make sure that
the poling of the battery is correct.
- If the LED flashes permanently du-
ring the transmission procedure: ex-
change the battery.
- If the radio receiver doesn´t react:
move closer to the radio receiver or
re-transmit the transmission code to
the radio receiver.
Disposal
Waste electrical products and batter-
ies not be disposed of with house-
hold waste!
Dispose of the waste product via a col-
lection point for electronic scrap or via
your specialist dealer.
Dispose of used batteries in a recycling
bin for batteries.
Put the packaging material into the re-
cycling bins for cardboard, paper and
plastics.
Warranty
Within the statutory warranty period we
undertake to rectify free of charge by
repair or replacement any product de-
fects arising from material or production
faults.
Any unauthorized tampering with, or
modifications to, the product shall ren-
der this warranty null and void.
Conformity
Hereby, hospicall GmbH declares that
the radio equipment type FU2-UMH is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of
conformity is available at the following
internet address: www.hospicall.com
Service
If, despite correct handling, faults or
malfunctions occur or if the product was
damaged, please contact the company
at the address below:
hospicall GmbH
Martin-Siebert-Str. 1
51647 Gummersbach
Germany
Phone: +49 2261 9583-100
Internet: www.hospicall.com
E-Mail: info@hospicall.com
UM114813C_25.10.2022 D/GB