Table of Contents
Advertisement
7.8 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
Press .
▶
7.9 Switching off automatic mode
Press , or .
▶
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
7.10 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting: 3
¡ Lowest setting: 1
¡ Highest setting: 5
7.11 Setting the sensor sensitivity
Requirement: The appliance is switched off.
Press and hold .
1.
a The setting is displayed after approx. one second.
Press , , ,
or
2.
Release
to save the setting.
3.
7.12 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Note: You can set the saturation indicator in the Home
Connect app depending on the filter used.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
8 Home Connect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the Home Connect app, adjust its basic settings
and monitor its operating status.
The Home Connect services are not available in every
country. The availability of the Home Connect function
depends on the availability of Home Connect services
in your country. You can find information about this at:
www.home-connect.com.
1
Depending on the appliance specifications
1
1
1
to change the setting.
7.13 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off,
appears on the display for the grease filter.
¡ After the appliance has been switched off,
appears on the display for the odour filter.
Press
.
▶
a The saturation indicator is reset.
7.14 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement: The appliance is switched off.
Press and hold
1.
To set circulating-air mode (non-regenerative fil-
‒
ter), press .
To set circulating-air mode (regenerative filter),
‒
press .
To set air extraction mode, press .
‒
Release
to save the setting.
2.
7.15 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Press
.
▶
7.16 Setting the brightness
Press and hold
until the required brightness is
▶
reached.
7.17 Switching on the audible signal
Requirement: The appliance is switched off.
Press and hold
and
▶
prox. three seconds until a signal sounds.
7.18 Switching off the signal tone
Requirement: The appliance is switched off.
Press and hold
and
▶
prox. 3 seconds.
a A signal tone will sound.
The Home Connect app guides you through the entire
login process. Follow the instructions in the Home Con-
nect app to configure the settings.
Tips
¡ Please consult the documents supplied by
Home Connect.
¡ Please also follow the instructions in the Home Con-
nect app.
Home Connect en
.
at the same time for ap-
at the same time for ap-
and 1
and 2
7
Advertisement
Table of Contents
