Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Dahua Technology DHI-IPMECD-3021 Series
- Page 1 Parking Barrier User's Manual ZHEJIANG DAHUA VISION TECHNOLOGY CO., LTD. V1.0.1...
-
Page 2: Foreword
User's Manual Foreword General This manual introduces the structure, installation, and maintenance of the parking barrier (hereinafter referred to as the "Barrier"). Read carefully before using the device, and keep the manual safe for future reference. Models Series Model DHI-IPMECD-3021-RM1515-T09 DHI-IPMECD-3021-LM1515-T09 DHI-IPMECD-3021-RM1525-T20 DHI-IPMECD-3011-LM1525-T20... - Page 3 User's Manual Signal Words Meaning Indicates a high potential hazard which, if not avoided, will result in death or serious injury. Indicates a medium or low potential hazard which, if not avoided, could result in slight or moderate injury. Indicates a potential risk which, if not avoided, could result in property damage, data loss, reductions in performance, or unpredictable results.
- Page 4 User's Manual using the device. ● If there is any uncertainty or controversy, we reserve the right of final explanation.
-
Page 5: Important Safeguards And Warnings
User's Manual Important Safeguards and Warnings This section introduces content covering the proper handling of the device, hazard prevention, and prevention of property damage. Read carefully before using the device, comply with the guidelines when using it, and keep the manual safe for future reference. Transportation Requirements Transport the device under allowed humidity and temperature conditions. - Page 6 User's Manual ● Do not disassemble the device without professional instruction.
-
Page 7: Table Of Contents
User's Manual Table of Contents Foreword ........................................I Important Safeguards and Warnings ............................IV 1 Introduction ......................................1 1.1 Overview ......................................1 1.2 Features ......................................1 2 Structure ........................................3 2.1 Appearance ....................................3 2.2 Dimensions ....................................4 2.3 Components ....................................4 3 Installation ....................................... -
Page 8: Introduction
User's Manual 1 Introduction 1.1 Overview The Barrier can be used together with a radar for access control in parking lots, and it primarily consists of a top cover, casing, drive unit, control box, and barrier arm. The Barrier can be divided into 2 categories depending on its arm position (right or left) when facing it. - Page 9 User's Manual ● Supports remote control at a maximum distance of 50 m (164 ft) with no interference.
-
Page 10: Structure
User's Manual 2 Structure 2.1 Appearance Straight Arm Barrier Figure 2-1 Straight arm barrier Folding Arm Barrier Figure 2-2 Folding arm barrier... -
Page 11: Dimensions
User's Manual 2.2 Dimensions Figure 2-3 Dimensions (mm [inch]) 2.3 Components Figure 2-4 Components... - Page 12 User's Manual Table 2-1 Components description Name Description Fixed to the casing by a lock, which can be unlocked Top cover with a key. Driven by a torque motor, it controls the arm to rise or Drive unit fall. Contains the control board, on which the barrier inverter Control box and connection terminals are installed.
-
Page 13: Installation
User's Manual 3 Installation 3.1 Installation Preparation ● This section introduces basic requirements for selecting and constructing the foundation. For details on installing the Barrier, see the construction guide. ● The foundation must be constructed before the Barrier is installed. Selecting Construction Site The center of the foundation should be more than 300 mm (11.81'') away from the road side. - Page 14 User's Manual Foundation Construction Requirements Figure 3-2 Foundation construction requirements (mm [inch]) Table 3-1 Foundation description Name Foundation bolt Foundation surface PVC pipe ● Pour concrete to construct a foundation of 500 mm× 500 mm (19.69''× 19.69'') (L × W), and make sure that the depth is between 150 mm–200 mm (5.91''–7.87'').
-
Page 15: Installing The Barrier
User's Manual After the concrete foundation hardens, drill 4 holes with a diameter of 16 mm (0.63'') to install ◇ the Barrier. Use M12 expansion bolts. Make sure that the thread length of the expansion bolt is longer ◇ than 80 mm (3.15''), and its total length is more than 150 mm (5.91''). The drilled holes and the installation position should meet the requirements shown in Figure ◇... -
Page 16: Installing The Folding Arm
User's Manual 3.2.2 Installing the Folding Arm Figure 3-5 Example of a successful installation Table 3-2 Parts description Description Description Mounting plate M14 nut and spring washer M14 × 140 hex head bolt and plain washer Fixing plate Step 1 Align the arm with the mounting plate, and fix the mounting plate to the arm with M14 ×... -
Page 17: Installing The Anti-Smashing Arm
User's Manual Arms shorter than 4 m (included) are anti-smashing. 3.2.3.1 Installing the Anti-smashing Arm Figure 3-6 Install the anti-smashing arm Step 1 Connect the LED light bar that is fed through the arm to the cable that comes out of the mounting plate. -
Page 18: Opening The Top Cover
User's Manual Step 1 Thread four M10 × 75 bolts and plain washers through parts 1, 2, and 3. Step 2 Fix the bolts with four M10 nuts and spring washers. 3.2.4 Opening the Top Cover Step 1 Lift the arm up to its vertical state. Step 2 Use your key to unlock the top cover, wait until the side of the cover near the arm is tilted, and then push the cover forward to open it. - Page 19 User's Manual Parameter Description ● ON: Enable automatic arm lifting during power failure. ● OFF: Disable automatic arm lifting during power failure. Counting mode: Under this mode, when the Barrier is powered on, and there is no anti-smashing signal triggered, the arm automatically falls.
-
Page 20: Remote Matching Description
User's Manual Parameter Description ● GODN: Close. +24V ● +24 V: Common signal port. Angle sensor ports. Drive motor ports. 220 VAC power supply ports for the barrier inverter. 3.3.2 Remote Matching Description Figure 3-9 Receiver ● Match the remote information Successful matching: Press and hold the learning button on the receiver for 2 s, press the ◇... -
Page 21: Wiring Instructions
User's Manual been cleared. 3.3.3 Wiring Instructions The wiring diagram can be found on the Barrier casing. Figure 3-10 Wiring diagram ● Connect to power: PE: Connect to earth wire. ◇ N: Connect to neutral wire. ◇ L: Connect to live wire. ◇... -
Page 22: Maintenance
User's Manual 4 Maintenance 4.1 Notes on Using the Barrier ● Avoid bumping during use. If bumping occurs, do the following: Check whether the slewing mechanism is damaged. If so, replace it in time. ◇ Check whether the barrier arm is bent. If so, replace it in time. ◇... -
Page 23: Maintaining The Angle Sensor
User's Manual normally when the Barrier opens or closes. ● Check whether the transmission part is loose and therefore affecting the running of the Barrier. ● Check whether there is any abnormal noise during the operation of the motor. If so, contact after-sales service. - Page 24 User's Manual Table 4-1 Spring matching standard Arm Type Arm Length (m) Number of Spring L ≤ 3.7 1 × 5.2 spring 3.7 < L ≤ 4.5 1 × 6.3 spring Straight arm with light bar 4.5 < L ≤ 5.0 2 ×...
-
Page 25: Appendix 1 Cybersecurity Recommendations
User's Manual Appendix 1 Cybersecurity Recommendations Cybersecurity is more than just a buzzword: it’s something that pertains to every device that is connected to the internet. IP video surveillance is not immune to cyber risks, but taking basic steps toward protecting and strengthening networks and networked appliances will make them less susceptible to attacks. - Page 26 User's Manual 1024–65535, reducing the risk of outsiders being able to guess which ports you are using. 6. Enable HTTPS We suggest you to enable HTTPS, so that you visit Web service through a secure communication channel. 7. MAC Address Binding We recommend you to bind the IP and MAC address of the gateway to the equipment, thus reducing the risk of ARP spoofing.
- Page 27 User's Manual ● Enable IP/MAC address filtering function to limit the range of hosts allowed to access the device. More information Please visit Dahua official website security emergency response center for security announcements and the latest security recommendations.
- Page 28 User's Manual...
Need help?
Do you have a question about the DHI-IPMECD-3021 Series and is the answer not in the manual?
Questions and answers