Related Manuals for DRYWISE 600591440003
Summary of Contents for DRYWISE 600591440003
- Page 1 PRE-HEATER ADD-ON FOR DRYWISE DRYER On-demand, repeatable and reliable filament drying U SER M A N UA L...
-
Page 3: Table Of Contents
Table of contents Introduction 1.1. Intended use of Pre-heater for Drywise dryer 1.2. General disclaimer Safety 2.1. General safety information 2.2. Health and safety The Drywise Pre-Heater add-on 3.1. Main components 3.2. Specifications Installation 4.1. Unboxing 4.2. What’s in the box 4.3. -
Page 5: Introduction
Please carefully read and understand the contents of this user manual. Failure to read the manual may lead to personal injury, inferior results or damage to the Drywise Pre- Heater, the Drywise dryer, the 3D Printer and/or its peripherals. Make sure that anyone who uses this device knows and understands the contents of the manual to make the most out of the Drywise Pre-Heater. -
Page 6: Safety
• Follow instructions and safety indicators on the screen of the dryer and/or follow safety warning labels on the product components. • Install the product to the Drywise drier well. When the device is connected to the 3D printer via filament, the forces of the extruder may pull the device. -
Page 7: The Drywise Pre-Heater Add-On
3. Pogo pins electrical connectors 2. Filament guiding tube 4. Thumbscrew opening 3.2. Specifications Properties Device Pre-heater add-on for Drywise Inline Filmanet Dryer Technology Fused filament fabrication filament pre-processing (FFF) Filament Diameter 2.85mm • Nylon materials and reinforced nylon materials from... -
Page 8: Installation
Take out the manual and any other leaflets. Remove the add-on and proceed to the installation. Choose a suitable location to place the Drywise inline filament dryer and the Drywise Pre-Heater add-on. Install the Drywise dryer on a flat, stable surface capable of with- standing the weight of the system and on which you can safely operate to install the add-on. -
Page 9: Hardware Installation And First Interaction
Remove input port cover d) Place the Pre-Heater add-on in place e) Re-install the dowel pin, f) The Drywise Pre-Heater flip close the the Pre-Heater add-on is ready for use. add-on and secure it with the thumbscrew... -
Page 10: Operation
Drywise Pre-Heater is correctly installed and functional. The Drywise dryer will automatically set the correct settings based on the filament chosen. It is essential to install the Drywise Pre-Heater to be able to use Drywise with the following materials: •... -
Page 11: Maintenance
The Drywise dryer will set the correct parameters for the specific filament selected. If a filament needs the Pre-Heater add- on and this is not installed the Drywise dryer will not allow you to choose said material for drying until the add-on is installed. -
Page 12: Warranty
8.1. General Thought3D Ltd grants a standard warranty on the Drywise Pre-Heater product (“Product”) in the country where the product was purchased. From the date the prod- uct is sold and delivered to an end-customer for the first time, as evidenced by the original customer’s purchase invoice, Thought3D Ltd warrants the product is free... -
Page 13: Notification
This warranty is exclusively governed by Malta law. Any dispute arising out of or in connection with this warranty will be exclusively submitted to the jurisdiction of the court of Malta. Any dispute shall be held in English. Drywise Pre-Heater User Manual...
Need help?
Do you have a question about the 600591440003 and is the answer not in the manual?
Questions and answers