Peavey SP 218P Product Specifications page 14

Front LED: Set front baffle LED operation to:
On: When power on indication is selected, the LED is lit blue whenever the amplifiers
are not shut down
Signal: When signal on indication is selected, the LED is lit blue whenever a signal is
qpresent at the input.
Off : The LED is turned off for all conditions..
Auto power off:
Security Lock: A four digit security lock that can be engaged that will block editing of all parameters. If locked,
entry of the access code will be required to allow temporary access for editing. It will automati
cally relock after 5 minutes of editing inactivity.
ALTERNATE METHOD OF CONNECTING A SATELLITE SPEAKER TO THE SUB
Instead of using the EQ presets in the Sub and feeding an equalized signal to the satellite speaker, and leaving the
satellite speaker in a flat mode, the following settings could be used instead.
The signal source (mixer, etc.) will still connect to the SP® 218P Sub first, then a cable from the High-Pass Pro-
cessed output jack would be connected to the satellite speaker input.
Then set the SP® 218P Sub for a Flat Preset, and use the Presets/EQ/Tone Controls on the satellite speaker to
shape it's response and behavior.
This would mean not following the Set-up Wizard's instructions for the SP® 2P, but it would provide a little more
flexibility of satellite speaker EQ, and allow the SP® 218P Sub response to be unaltered in it's frequency response,
and then use the relative level of the Sub as the means of tonal balance adjustment. Turn the satellite speaker gain
or volume control down to increase the SP® 218P Sub's apparent output level, and then turn the Sub's gain control
up to get the overall gain back. To decrease the SP® 218P Sub's apparent output level, turn the satellite speakers
gain or volume control up, and turn the SP® 218P Sub gain control down to get back to the overall level point.
Disable, 15, 30 or 60 minute delay.