Lexus NX 300h 2020 Owner's Manual page 324

322
5-5. Using the other interior features
Programming the HomeLink
Before programming the Home-
■
®
Link
 During programming, it is possible
that garage doors, gates, or other
devices may operate. For this rea-
son, make sure that people and
objects are clear of the garage door
or other devices to prevent injury or
other potential harm.
 It is recommended that a new bat-
tery be placed in the remote control
transmitter for more accurate pro-
gramming.
 Garage door opener motors manu-
factured after 1995 may be
equipped with rolling code protec-
tion. If this is the case, you may need
a stepladder or other sturdy, safe
device to reach the "learn" or
"smart" button on the garage door
opener motor.
Programming the HomeLink
■
1 3
Steps through
within 60 seconds, otherwise the indi-
cator light will stop flashing and pro-
gramming will not be able to be
completed.
1
Press and release the HomeLink
button you want to program and
check that the HomeLink
tor light flashes orange.
2 Point the remote control transmit-
ter for the device at the rear view
mirror, 1 to 3 in. (25 to 75 mm)
from the HomeLink
®
®
must be performed
®
®
indica-
®
buttons.
®
Keep the HomeLink
view while programming.
3
Program a device.
Programming a device other than

an entry gate (for U.S.A. owners)
Press and hold the remote control trans-
mitter button until the HomeLink
tor light changes from slowly flashing
orange to rapidly flashing green (rolling
code) or continuously lit green (fixed
code), then release the button.
Programming an entry gate (for

U.S.A. owners)/Programming a
device in the Canadian market
Press and release the remote control trans-
mitter button at 2 second intervals, repeat-
edly, until the HomeLink
changes from slowly flashing orange to
rapidly flashing green (rolling code) or
continuously lit green (fixed code).
4
Test the HomeLink
pressing the newly programmed
indicator light in
®
indica-
®
indicator light
®
operation by