Advertisement
OPERATION OF THE FX12
The FX12 can be operated in front of an amplifier or in
an effects loop. It should be noted that for the most
accurate tune, the FX should be run first in the chain
of effects. Since the order of the effects is very impor-
tant, they should be ordered as follows: 1)FX12 Tuna,
2) compression effects (DOD FX84), 3) Wah/volume
and envelope filters (DOD FX17, FX25), 4) Distortion
effects or preamps (DOD FX51, FX69), 5) EQ's (DOD
FX40), 6) chorus, flanging, phasing, vibrato (DOD
FX64, FX75, FX20, FX747), 7) Delay and reverb effects
(DOD DFX94).
IMPORTANT NOTES
• The FX12 battery is in use whenever the
• Remove the battery whenever the unit is
• If the FX12 fails to switch in or out or the
• Use of any AC adapter other than the
INPUT jack is plugged in. If you are not
using the FX12, be sure to unplug the
cable from INPUT jack. This will prevent
unnecessary battery drain.
not going to be used for an extended
period of time. This will prevent possible
damage due to leaking battery fluids.
Note Indicator goes blank, the battery
needs to be replaced. Replace the bat-
tery immediately.
DOD PS200R will void the warranty of
this product.
Advertisement
