Table of Contents
Advertisement
Quick Links
TR00C02KNX
TR00C02KNX-3M Transponder reader with 3 control buttons + BLE beacon + knx secure -
TH00C02KNX
TH00C02KNX-3M Transponder holder with 3 control buttons + BLE beacon + knx secure -
Transponder reader with 3 control buttons + BLE beacon + knx secure
3 Modules
Transponder holder with 3 control buttons + BLE beacon + knx secure
3 Modules
USER MANUAL
Translation of the original instructions
Version: 1.0
Date: 30/03/2023
Advertisement
Table of Contents
Summary of Contents for Eelectron TR00C02KNX
- Page 1 TR00C02KNX Transponder reader with 3 control buttons + BLE beacon + knx secure TR00C02KNX-3M Transponder reader with 3 control buttons + BLE beacon + knx secure - 3 Modules TH00C02KNX Transponder holder with 3 control buttons + BLE beacon + knx secure...
-
Page 2: Table Of Contents
TR00C02KNX | TH00C02KNX Index Introduction to the user manual ..............................4 Meaning of the symbols used ..............................4 Products overview ..................................4 Installation instructions ................................5 Sequence for wall mounting ..............................5 Configuration and commissioning ............................. 6 General parameters .................................. 6 Front panel ....................................7 General alarms .................................. - Page 3 TR00C02KNX | TH00C02KNX Any information inside this manual can be changed without ad- vice. This handbook can be download freely from the website: www.eelectron.com Exclusion of liability: Despite checking that the contents of this document match the hardware and software, deviations cannot be completely exclud- ed.
-
Page 4: Introduction To The User Manual
The upper part of the glass is backlit (to illuminate the room num- scribes the functions and parameters of the products: ber or a logo - both customizations on request); in the lower part • TR00C02KNX: Transponder reader with 3 control buttons + there are freely configurable backlit capacitive buttons. BLE beacon + knx secure •... -
Page 5: Installation Instructions
TR00C02KNX | TH00C02KNX 3. Installation instructions The device can be used for permanent internal installations in dry places. WARNING • Device must be installed at a minimum distance of 4 mm between electrical power line (mains) and input cables or red / black bus cable. -
Page 6: Configuration And Commissioning
/ correct online activity. The the device parameters the corresponding application program or notification can take place spontaneously (periodically - settable peri- od value) or following a query (upon request). The value of the 1-bit the whole eelectron® product database must be loaded in the notification telegram can be set. ETS® program. Telegram value... -
Page 7: Front Panel
TR00C02KNX | TH00C02KNX Buzzer during night disabled / enabled Unsupported card cyclic sending never / 1,5,10,30 min / 1,2,6,12 h Defines whether to enable or disable the buzzer in the night time. Defines the time interval for cyclical sending of the “<General>Not Supported Card Alarm” object. Buzzer action no / yes Front panel Defines whether to activate the buzzer signal in case of an alarm. -
Page 8: Knx Secure
TR00C02KNX | TH00C02KNX 9. LEDs-RGB Led KNX Secure In order to use a device “safely”, the ETS project must first be Please refer to the “LEDs-RGB Led” user manual. protected with a password. In the devices described, the “access control” func- tion is not available. 10. Thermostat Please refer to the “Thermostat and additional probe”...
Need help?
Do you have a question about the TR00C02KNX and is the answer not in the manual?
Questions and answers