Kenwood KMM- BT508DAB Instruction Manual page 41

Digital media receiver
Table of Contents

Advertisement

Available languages

Available languages

Installation/Connection
Connect external components
No
Part
1
Microphone input jack (Page 15)
2
Output terminals (See the following "Connect external amplifiers via output terminals".)
3
DAB antenna jack (Page 7, 36)
Connect external amplifiers via output terminals
When connecting an external amplifier to the output terminals of this unit,
securely connect the amplifier ground wire to the car chassis to prevent
damage to the unit.
Output terminals
2-way crossover
FRONT:
Front output
REAR/SW:
Rear/subwoofer output
Installing the DAB antenna
Connect the DAB antenna to the DAB antenna jack. (See the left column.)
• DAB antenna is supplied for
For details, see the following.
• For
For details, refer to the instruction manual supplied with the DAB antenna.
• The film antenna (F) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver's view.
– where it may obstruct the operation of safety devices such as air bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following locations:
– on IR reflecting glass or locations covered with mirror type glass film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is turned
– depending on the direction of the broadcast station with respect to the
3-way crossover
• Thoroughly wipe oil and dirt from the pasting surface with the supplied
Mid Range output
cleaner (I).
• Do not bend or damage the film antenna (F).
Woofer output
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (F) and amplifier unit (G)
before pasting.
• Do not apply any glass cleaner after pasting the film antenna (F).
, you need to purchase the DAB antenna separately.
CAUTION
insulation glass).
on.
vehicle (antenna).
.
33
ENGLISH

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kmr-m508dab

Table of Contents