Removing The Presser Foot Holder - Brother 888-V13 Operation Manual

GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e Place the presser foot to be installed below the
holder so that the presser foot pin is aligned
with the notch in the holder.
Position the presser foot so the letter indicating
the presser foot type (J, A, etc.) is positioned to
be read.
a
b
c
a Presser foot holder
b Notch
c Pin
d Presser foot type
Memo
● The code for the presser foot to be used
with each stitch appears in the LCD. For
details on selecting a stitch, refer to
"Selecting a stitch" (page 42).
f Slowly lower the presser foot lever so that the
presser foot pin snaps into the notch in the
presser foot holder.
a
b
c
d
The presser foot is attached.
34
4
J
a Presser foot lever
b Presser foot holder
c Notch
d Pin
g Raise the presser foot lever to check that the
presser foot is securely attached.
Removing the presser
foot holder
Remove the presser foot holder when cleaning the
sewing machine or when installing the optional
walking foot.
a Remove the presser foot.
• For details, refer to "Replacing the presser
foot" (page 33).
b Loosen the presser foot holder screw, and
then remove the presser foot holder.
Turn the screwdriver counterclockwise.
a
c
a Screwdriver
b Presser foot holder
c Screw
b