Servicing The Blades - Toro 74571 M74571 Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

4. Carefully slide the paper element and the foam element

from the blower housing (Fig. 31).

Figure 31

1. Paper element

2. Foam element

3. Air cleaner cover

Cleaning the Foam and Paper Elements

Foam Element

1. Wash the foam element in liquid soap and warm water

and rinse it thoroughly.

2. Dry the element by squeezing it in a clean cloth.

Note: Do not oil the foam element.

Important

Replace the foam element if it is torn or

worn.

Paper Element

1. Lightly tap the paper element on a flat surface to

remove dust and dirt.

2. Inspect the element for tears, an oily film, and damage

to the rubber seal.

Important

Never clean the paper element with

pressurized air or liquids, such as solvents, gasoline, or

kerosene. Replace the paper element if it is damaged or

cannot be cleaned thoroughly.

5 4

4. Tab

5. Slot

6. Blower housing

Installing the Foam and Paper Elements

Important

To prevent engine damage, always operate

the engine with the complete foam and paper air cleaner

assembly installed.

1. Place the foam element and paper element into the

blower housing.

Note: Ensure that the rubber seal is flat against the air

cleaner base.

2. Align the tabs on the air cleaner cover with the slots of

the blower housing (Fig. 31). Hook the handle onto the

cover and press down on the handle to lock the cover in

place.