Installation - Sony XAV-AX3200 Operating Instructions Manual

Using an A/V device
Installation of a mini-jack A/V cable (not supplied)
is required before use.
1
Connect the installed mini-jack A/V cable to
the Video Output terminal of the A/V
device.
Do not connect to the Video Input terminal of
the A/V device.
2
Press HOME, then touch [A/V IN].
CAUTION
Be sure to use a mini-jack A/V cable (not supplied)
for wiring. Using other cables with different wiring
positions might result in disturbed images and
sound.
L
R
G
V
L: Left audio (White)
R: Right audio (Red)
V: Video (Yellow)
G: Ground (earth)
Notes
• Only connect to the A/V IN terminal of this unit. Do not
connect to other terminals, such as MIC IN or REMOTE IN.
• Refer to the instructions supplied with your A/V devices for
details about connecting and using the A/V device.
16
GB
L
V
G
R

Installation

Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.

Bracket
Parts supplied with
your car
When mounting this unit to the preinstalled
brackets of your car, use the mounting screws  in
the appropriate screw holes based on your car:
T for TOYOTA and N for NISSAN.
Note
To prevent a malfunction, install only with the mounting
screws .
Fuse replacement
When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse.
If the fuse blows, check the power
connection and replace the fuse.
If the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
To the dashboard/center console
Bracket
Fuse (10 A)
