Advertisement
STEP 3
A. Fasten (4) Lifting Lugs to Left and Right Side
Panels with (4) 3/8 in. x 1 in. thread cutting
screws and (4) Lifting Lug Backers.
B. Fasten (2) Front and (2) Back Retaining
Angle sections to the Cover End with
sheet metal screws as shown in the
bubble.
For the filter option, go to Step 4
C. Slide (4) Birdscreen sections up
between Front and Back Retaining
Angles. Then slide bottom of (4)
Birdscreens into Lower Holder Panel. If
you are going to attach weatherhood to
unit after assembly, complete this step
after the weatherhood is fastened to
the unit.
STEP 4
A. Fasten (2) Bottom Filter Plate sections to Lower Holder Panel with sheet metal screws.
Lower Holder Panel
Bottom Filter Plate
Back Retaining Angle
Front Retaining Angle
Copied from previously supplied drawing. This drawing wa
Weatherhood Assembly Instruction. Part #457935. This pie
The drawing supplied by Eric St. Ours on October 16, 2007
exploded view and he wanted it maintained in this version.
Model TSU50 Weatherhood
3
Advertisement
