Material No. Page TC-442 2/6 1. 概 説 Outline 本工具は、予め外被むきした電線とコンタクトを圧着する手動工具です。 ラチェット機構が付いているので安定した圧着ができます。 This is a manual tool to crimp a contact and a cable whose jacket is a already stripped. This tool has a ratchet to get stable crimping quality. 2.適用コンタクト Applicable Cable and Contact 表-1...
Material No. Page TC-442 3/6 4.圧着準備 Crimping 電線を表-2の寸法で外被むきを行なって下さい。 《図-2参照》 Strip the jacket of the cable as shown in Table 2. 《Fig 2》 表-2 Table 2 外被むき長さ 適 用 電 線 使用コンタクト Stripping Length Applicable Applicable contact cable of jacket 《図-2》 《Fig 2》 DK-5RECS×××...
Page 5
Material No. Page TC-442 4/6 2)コンタクトのセット Setting a contact コンタクトを図-4,5の様な向きにして、コンタクト先端をロケータの穴の中に入れて下さい。 バレル開口部が上を向く様にセットして下さい。 《図-5参照》 注)コンタクトをセットしている間、ハンドルを手で開いて保持して下さい。 Set the contact in the position shown in Fig 4 and 5. Then insert the contact in the locator hole. Set the contact with the barrel opening facing upward.《Fig 5》 Caution: In setting the contact, manually open the handle and hold it.
Page 6
Material No. Page TC-442 5/6 4)圧 着 Crimping 挿入した電線とコンタクトがズレない様にしながら、ハンドルを徐々に締め付けます。 ラチェットが外れるまで締め付けて下さい。これで圧着は完了です。 《図-8,9参照》 注)圧着終了後もハンドルを手で開いて下さい。 Confirming the inserted cable and the contact in full alignment, slowly fasten the handle. Fasten the handle until the ratchet releases. Here is the end of crimping process.《Fig 8 and 9》 Caution: After the crimping steps, manually hold the handle open.
Contact name ワイヤバレル m㎡ Wire barrel 1.23~2.00 1.81~2.00 DK-5RECS××× DK-5TABS××× 2.00~2.27 1.81~2.23 7.メンテナンス Maintenance ・保証期間は、1年間です。 ・故障の際、弊社にて修理を行ないますので、ハンドツールごと営業に渡して下さい。 ・This tool guaranteed for one (1) year. ・Failures will be repaired by DDK. Give the hand tool to DDK’s salesperson along with the hand tool.