Summary of Contents for Fairlight DREAM Station SCP1
- Page 1 SCP1 Station Channel Meter Panel Installation Manual DREAM Software Version: 1.1 Part No: DBE1201-A Document No: 220...
- Page 2 Important Notice COPYRIGHT The material in this document is copyright to Fairlight ESP Pty Ltd, and may not be quoted or re- produced in any form without written permission from the company. Fairlight is a trademark of Fairlight ESP Pty Ltd. All other trademarks are the property of their re- spective owners.
- Page 3 OBTAINING TECHNICAL SUPPORT Users requiring technical support should contact their local Fairlight office or dis- tributor. Information can also be found on the world wide web at: http://www.fairlightesp.com FAIRLIGHT OFFICES WORLD-WIDE USA West Coast USA East Coast Fairlight USA Fairlight USA...
-
Page 4: Table Of Contents
Table of Contents Chapter 1: Introduction INTRODUCTION............. . 1-1 ABOUT THIS MANUAL . -
Page 5: Chapter 1: Introduction
The DREAM Station Channel Meter Panel provides high resolution signal level metering for the Fairlight DREAM Station integrated mixer/editor. The Station is part of a new family of products from Fairlight which marries together QDC processing with an ergonomic physical control surface in a combination that has a significant impact on productivity and efficiency. - Page 6 NOTES:...
-
Page 7: Chapter 2: Installation
C h a p t e r 2 - I n s t a l l a t i o n INTRODUCTION The DREAM Station Channel Meter Panel is designed to be mounted directly to the rear of the DREAM Sidecar. One simple cable connection between the Sidecar and Meter Panel using the five pin XLR cable supplied, is also required. -
Page 8: Connecting Two Meters
Connecting Two Meters When more than one Sidecar is present, the meters should be connected as shown below. The Sidecars must both be connected directly to the Station. Figure 2: Connecting Two Sidecars CONFIGURATION If the Meter Panel has been purchased separately from the Station, the Station must be configured to establish communication with the Meter Panel via USB. -
Page 9: Configuring Two Meter Units
Figure 3: ConsCon Window Configuring Two Meter Units If two Channel Meters are to be fitted, the Fairlight distributor must be informed prior to shipping in order for the panel configuration of the second meter to be modified. When two Channel Meters are present, the first meter is configured with panel ID 15, the second meter with ID 16. - Page 10 NOTES:...
-
Page 11: Chapter 3: Specifications
C h a p t e r 3 - S p e ci f i c at i o n s WIRING AND CONNECTION DETAILS Connector sex described is the panel mount connector on the rear of the unit. Meter USB Description: USB and DC Power connection. - Page 12 Index - i Index Add Panel ....2-4 AMIX119-A ....2-2 Configuration .