Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Voltera V-ONE DRILL
- Page 2 For consumables and replacement parts, please contact our sales team or visit our online store: sales@voltera.io +1 888-381-3332 Ext. 1 voltera.io/store For technical assistance, please reach out to our technical support team: support@voltera.io +1 888-381-3332 Ext. 2 voltera.io/support 180 Northfield Dr W Suite 2...
-
Page 3: Table Of Contents
Removing the Drill • Mount the Sacrificial Layer • Third Party Drill Bits • Changing Drill Bits Maintenance • Inspect Drill Bits Before Use • Replacement Power Cable • Cleaning V-One Drill Specifications • Hardware Consumables & Accessories • Consumables • Accessories... -
Page 4: Safety
Sharp Tools The drill bits included with the V-One Drill are sharp. When the drill bits are not in use, remove them from the V-One Drill, and store them in the provided case to prevent damage to the equipment and accidental injury. -
Page 5: Drill Anatomy
Drill Anatomy Front 1. Drill Bit 2. Set Screw 3. Motor Back 1. Contact Pads 2. Power Entry... -
Page 6: Using The Drill
5. When prompted by the Voltera V-One software, mount the V-One Drill unit on the Voltera V-One as instructed, and connect the male end of the adapter to the female barrel jack on the V-One Drill. 6. Ensure the two LEDs on the top of the V-One Drill are illuminated, and that the audible startup sequence has been completed. -
Page 7: Maintenance
Drill bits may break if not handled correctly or become dull with use. Ensure the drill bits are not damaged before using and inspect drill bits before storing. Cleaning During operation, the V-One drill will generate dust debris. This debris should be cleaned after drilling has been completed using a dust extractor. Replacement Power Cable Replacement power cable depends on electrical standards of the country and locality of use. - Page 8 V-One Drill Technical Specifications Disclaimer: Voltera reserves the right to change or update the following specifications at any time without notice. Please visit www.voltera.io or contact support@voltera.io most up-to-date information. Hardware Maximum Speed 13000 RPM Maximum Drill Bit Length 38.1mm 1.5”...
- Page 9 For consumables and replacement parts, please contact our sales team or visit our online store: sales@voltera.io +1 888-381-3332 Ext. 1 voltera.io/store For technical assistance, please reach out to our technical support team: support@voltera.io +1 888-381-3332 Ext. 2 voltera.io/support 180 Northfield Dr W Suite 2...
Need help?
Do you have a question about the V-ONE DRILL and is the answer not in the manual?
Questions and answers