Philips HR1947 User Manual page 7

Before first use
Thoroughly clean all parts before you use the appliance for the first time (see
chapter 'Cleaning').
Note: Make sure all parts are completely dry before you start using the appliance.
Preparing for use
Assembling the juicing unit
1 Attach the pulp outlet to the juicing unit and turn it clockwise until the arrow
( ) points to the 'locked' indication. (Fig. 2)
2 Insert the juicing screw into the juicing unit (Fig. 3).
3 Assemble the two parts of the filter (Fig. 4).
4 Place the two-part filter over the juicing screw (Fig. 5).
Tip: Use the black two-part filter for clear juice. If you prefer cloudy juice with
more fibres in it, use the grey two-part filter.
5 Attach the spout to the juicing unit and turn it clockwise until the arrow (
points to the 'locked' indication. (Fig. 6)
Important: Do not attach or detach the spout when the juicing unit is mounted on
the motor unit. Always take off the juicing unit from the motor unit before
assembling or disassembling.
6 Place the berry tray on the feeding tube (Fig. 7).
Placing the juicing unit onto the motor unit
1 Place the assembled juicing unit onto the motor unit, with the pulp outlet
fitting into the opening on the motor unit (Fig. 8).
2 Align the projections on the juicing unit with the recesses in the motor unit.
Slide the juicing unit onto the motor unit until it locks into place. (Fig. 9)
3 Press the juicing unit onto the motor unit (1) and then close the locking clamp
(2). (Fig. 10)
Note: If the locking clamp cannot be closed, check if the juicing unit is positioned
properly with the projections on the juicing unit into the recesses of the motor
unit.
4 Slide the pulp container into the motor unit (Fig. 11).
ENGLISH
9
)