Advertisement
Advertisement
Table of Contents
Related Manuals for TOPMAQ WB1520D4
Summary of Contents for TOPMAQ WB1520D4
- Page 1 W W B B 1 1 5 5 2 2 0 0 D D 4 4 W W B B 1 1 5 5 2 2 0 0 D D 4 4...
- Page 2 W W B B 1 1 5 5 2 2 0 0 D D 4 4...
- Page 3 W W B B 1 1 5 5 2 2 0 0 D D 4 4...
- Page 4 M M a a c c h h i i n n e e P P r r o o d d u u c c t t F F e e a a t t u u r r e e s s Table Top x 1 Shelf x 1 Cross Brace x 2...
- Page 5 1.Insert the cross nut with groove (8) 3.After both feet have been attached to into the frame strut (3). Align the cross the frame strut, the shelf (2) is pushed nut so that the groove is horizontal. into the groove. 4.Align the second frame strut (3) and fasten it again with the cross nuts with 2.Fasten the frame strut to the foot (4)
- Page 6 5.The lower support (15) is attached to 8.The partition is also attached to the the front with the 50mm screws (6) at frame with the screws (13). Warning: both ends of the feet. there are no pre-drilled holes. 6.The lower support (15) is also attached to the partition wall with rails (14) using the 50mm screws (6).
- Page 7 11.Finally, the back of the drawer (17) 13.Slide the drawers into the guides. is attached to the two side parts. Then insert the bottom of the drawer. 12.After installing all the drawers, 14.Finally, fasten the holding rods (10) check whether the inner tracks of the and the bench hooks (11) in the holes drawer pull-outs are pushed all the provided on the worktop.
- Page 8 Screw Table Top Sliding Partition Shelf Pull-up brace Cross Brace Drawer Front Panel(P1) Vice Drawer Back Panel(P2) Screw(50mm) Drawer Panel(P3) Bolt(60mm) Drawer Slot Panel(P4) Connecting Nut Drawer Bottom(P5) Hex Wrench(50mm) Drawer Handle Anvil Peg Drawer Screw Vice Screw and Washer W W B B 1 1 5 5 2 2 0 0 D D 4 4...
Need help?
Do you have a question about the WB1520D4 and is the answer not in the manual?
Questions and answers