The RGY Button's tri-color LED light ring provides
recorder system status, and indicates video loss
conditions. The button activates an alarm/event input
to mark video. The RGY Button is compatible with
TH8, NH16, and DH series recorder platforms.
Typical Installation Package
•
RGY Button with 5 ft./1.5m pigtail
(part # 065-1010)
•
RGY extension harness (20ft./6m)
(part # 060-1197)
•
Button & Signals harness (part # WT2)
Recorder Configuration
1. Power up the recorder with a monitor and
USB mouse connected, then right-click in Live
view and select Configuration.
2. Select System to open System Settings.
3. In the Diagnostic Indicator drop-down menu,
select RGY Button.
4. Click Back to save changes..
© Safe Fleet 2020 | All rights reserved
Installation Procedure
1. Determine the proper location before drilling
the mounting hole. Ensure the area behind the
hole is clear of obstructions before drilling.
2. Drill a 3/4" hole in the desired location. File the
edges if necessary.
3. Remove the mounting nut from the
shown.
4. Feed the connector and the cable through the
mounting hole, and re-attach the nut.
5. Connect the RGY Button's 5-pin connector to
the RGY extension harness (060-1197),
6. Connect the extension harness to the Button &
Signal harness' (WT2) 5-pin connector.
7. Connect the WT2's 2x6 Microfit to the
SIGNALS socket on the recorder.
8. Set up the recorder for the RGY Button (see
"Recorder Configuration").
RGY Button
Quick Start Guide
button as
Part # 700-1233 R1