Advertisement
Quick Links
Installation and Operation Manual
Blue Latch
Specifications
Temperature Range: 40-100°F (4.4-37.8°C)
Pressure Range: 20-125 psi (1.4-8.62 bar)
The LVPO F-1 System is Tested and
Certified by NSF International against
NSF/ANSI Standard 42 for the reduction
of Chlorine Taste & Odor.
911-760d LVPO F-1 F-2 F-3 IO NO09.indd 1
911-760 Rev D NO09
LVPO F-1, LFVO-F2, LVPO F-3
11" x 8.5" folded to 5.5" x 8.5"
Prints Black • updated 22 October 2009
(Outlet)
94-399-00
94-470-01
94-470-02
Gray Latch
(Inlet)
NOTE: Ball valve with gray
handle install in filter opening
with gray latch (inlet)
Ball valve with blue handle
installs in filter opening with
blue latch (outlet)
United States and foreign patents pending.
The LVPO F-2 is Tested and Certified
by NSF International against NSF/ANSI
Standard 42 for Nominal Particulate
Class III.
12/1/09 8:16:43 AM
Advertisement
Summary of Contents for SHURflo LVPO F-1
- Page 1 NSF/ANSI Standard 42 for the reduction Standard 42 for Nominal Particulate of Chlorine Taste & Odor. Class III. 911-760d LVPO F-1 F-2 F-3 IO NO09.indd 1 12/1/09 8:16:43 AM 911-760 Rev D NO09 LVPO F-1, LFVO-F2, LVPO F-3 11" x 8.5" folded to 5.5" x 8.5"...
- Page 2 Temperature = 40-100° F (4.4-37.8° C) = 7.5 +/- 1 Temperature = 68°F +/- 5°F (20°C +/- 2.5°C) Testing was performed under standard laboratory conditions, actual performance may vary. 911-760d LVPO F-1 F-2 F-3 IO NO09.indd 2 12/1/09 8:16:43 AM...
- Page 3 Inline Water Filtration System Installation Recommendations Figure 1 The LVPO F-1, LVPO F-2 and LVPO F-3 Series Inline filters are only effective when water flow is consistent with the directional flow arrow identified on the filter. Install the filter with the water flow following the direction of the arrow on the label.
- Page 4 SHURflo. Inline Water Filter System failure due to foreign debris is not covered under the terms of this limited warranty. SHURflo will not warrant any Inline Water filter System which is modified outside the SHURflo factory.
Need help?
Do you have a question about the LVPO F-1 and is the answer not in the manual?
Questions and answers